RangeRoller dt
Well-Sprung Member
- Posts
- 14,393
- Location
- Trapped inside my head @ LZ asylum
What did you do with your Range Rover today
- Thread starter Dopey
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
RangeRoller dt
Well-Sprung Member
- Posts
- 14,393
- Location
- Trapped inside my head @ LZ asylum
If you want to look up which you should have, all it is …. Is….they don’t go off MY they go by VIN. The information is on here somewhere coz that’s where I got it.
Flossie
Well-Known Member
- Posts
- 11,001
- Location
- Shropshire
Interesting. However(I assume you are talking about the rear view mirror issue?) There was no where on the online form to put the vin only the reg and if it's tinted, oh, and if it has solar glass. The autoglass guy muttered something about someone has fitted the BMW rv mirror as it's the early type (I dunno!) So maybe their glass and mirror mount was correct and some previous owner has fitted an earlier rv mirror, the screen isn't original.
She's a dhse so should have the dipping mirror and does.
Scotiawhiskers
Well-Known Member
- Posts
- 878
- Location
- Manchester
Both sides did that on Otto.Got the passenger side head off today
There was heaps of coolant in the head and it spilled into the 4th cylinderThe cylinder probably ended up being 1/5th full of coolant and oil which is un-ideal. Put a bunch of rags in to soak it up.
Hopefully drivers side head off tomorrow!
Soaked it up with an old bath sponge, wiped dry with kitchen roll, then sprayed it with high flashpoint solvent to drive out water, left that to evaporate and then lightly oiled them against corrosion. Been fine since.
- Posts
- 6,166
- Location
- North Manchester
I discovered that you can change what appears in the cluster display by selecting the options in here
- Posts
- 33,601
- Location
- North Shropshire
That's not been blowing, the HG is clean and i would say not a crack
Yeah, no steam cleaned cylinders.
I've had overpressuring and sluggish underload/when hot. So something is askew.
Found these on the HG as well.
Attachments
- Posts
- 33,601
- Location
- North Shropshire
I don't know what's going on there but when aHG blows it's usually burnt away with lots of carbon in the area. The fire rings look clean and intact
- Posts
- 33,601
- Location
- North Shropshire
The cracks in a rv8 that occur when we talk about a cracked block and slipped liners usually occur part way down the cylinder around the base of a head bolt where it's nice and thin. You can't see it while the liner is in place
- Posts
- 33,601
- Location
- North Shropshire
For anyone who cares to read .
The last word on Land Rover liner failures - I hope!
Thoughts and advice on caring for Rolls-Royce, Land Rover, and other fine European automobiles from John Elder Robison, owner of JE Robison Service.
robisonservice.blogspot.com
Scotiawhiskers
Well-Known Member
- Posts
- 878
- Location
- Manchester
I think you'll be fine. We gave Otto's blocks a gentle polish using light oil and 2000 grit wet or dry wrapped tightly around a plasterer's float. His gasket was totally burnt away between the front 2 cylinders on the driver's side. Been fine for 5000+ miles now. Heads were both skimmed a bit too.
biketeacherdave
Well-Known Member
- Posts
- 4,885
- Location
- south east london
Got it dirty
kds
Well-Known Member
- Posts
- 2,262
- Location
- old,ugly, tired in Lincoln.
Just got the car have you @backinblack ?
What symptoms lead you to remove the heads in the first place?
I was really hoping to find something obviously wrong with my headgasket because I have symptoms
- Posts
- 33,601
- Location
- North Shropshire
If you're getting over pressuring there's several reasons.. small leaks, blockage in the small pipes - there's 3, 2 for the throttle body heater and 1 radiator bleed return. Also i think the throttle body can leak (not sure)What symptoms lead you to remove the heads in the first place?
I was really hoping to find something obviously wrong with my headgasket because I have symptoms
Do you leave lpg? The vapourisors can leak lpg into the coolant.
- Posts
- 6,166
- Location
- North Manchester
kds
Well-Known Member
- Posts
- 2,262
- Location
- old,ugly, tired in Lincoln.
Know what you mean, don't think got enough years left in me to work all the way through the hand book and understand it all lol.Only had it 6 years, still learning
I’ve done the coolant system dance till I was blue in the face. Going through radiators, hoses, replaced this and that. Ended up getting a sniff test that confirmed bubbles coming up in the overflow tank. Which is why I pulled the heads.
No LPG.
- Posts
- 6,166
- Location
- North Manchester
