stuu
Well-Known Member
- Posts
- 1,946
- Location
- Aberdeenshire
I think the dervs use a lot more getting upto temp
My 320d would do 50-65mpg but on an 8 mile commute use the same as my 4.2 does
What did you do with your Range Rover today
- Thread starter Dopey
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
My 320d would do 50-65mpg but on an 8 mile commute use the same as my 4.2 does
- Posts
- 33,600
- Location
- North Shropshire
Mine does take a while to warm up but does the same mpg on my 15 mile commute as a 120 mile run on the A55
rich28uk
Well-Known Member
- Posts
- 635
- Location
- Manchester
Agree about its gears, when cruising and floor it kick down couple of gears and off it goes, although mine has a bad wobble about 80mph, rear lower arm on nearside front has a split bush stuck wheel wobbles about a bit, going to get a set of arms for about £150 and refresh all front end.Yeah it starts to accelerate in whatever gear it in on the torque then goes if i drop a gear or a few i can shift, if you do it at 40 45mph from coasting in 5th or 6th and click the kickdown it'll throw right back too 2nd and land at 4500rpm and mke all the nice noises and squat
Its very different to tow with as you feel it lock in or 'short shift' gears differently i expected it to be quite revvy towing, 2nd gear it holds a bit longer towing but the rest it still keeps it 2-3k revs,
My pal actually went from an ml27cdi to an ml500 just after i got this and is away to get an ml55amg so il be keen to see what thats like
1988smithy
Well-Known Member
- Posts
- 4,044
- Location
- West midlands
Double check wheel balance as well mate, mine was really shaky at motorway speeds but all 4 balanced and its much better. Still need the wheels truing up though. Needs rear hub bushes for next mot as well
stuu
Well-Known Member
- Posts
- 1,946
- Location
- Aberdeenshire
Have you found if you do a full throttle pull but not kickdown for a few seconds in gear then coast it will actually hold that gear like a manual until you decide if your accelerating or breaking again? I thought it was broken but its the way its programed that took a little getting use too after the td6 with the 5speed
stuu
Well-Known Member
- Posts
- 1,946
- Location
- Aberdeenshire
Remember and bolt them tight with the motor on the floor or hub jacked upto road height position
1988smithy
Well-Known Member
- Posts
- 4,044
- Location
- West midlands
Yep mine does that, like manual engine breaking very handy
stuu
Well-Known Member
- Posts
- 1,946
- Location
- Aberdeenshire
Its here at last 
rich28uk
Well-Known Member
- Posts
- 635
- Location
- Manchester
Can’t say iv noticed, may give that a try, definitely behaves differently to the gm5 speed in the td6s, same zf6 as in my old x5 but does have different programming as it drives different.
Mechanic who’s just done my tyres said how nice them engines sound even just Sat idling.
Spoke to him about the violent viberation, his guess is possibly front prob, possibly lost a weight, he’s just had it on a Nissan navara, but he was going to check balance on the old wheels but we were talking so he got side tracked, but at least 1 weight was missing from passenger side front which is where it feels to shake from.
Out of interest would warped or in some way knackered brake discs cause a viberation, not when braking though? He did have a look at the suspension arm and said even through it has more play than it should it shouldn’t cause what I’m describing.
rich28uk
Well-Known Member
- Posts
- 635
- Location
- Manchester
Supercharger pulley?Its here at last
rich28uk
Well-Known Member
- Posts
- 635
- Location
- Manchester
Rear hub bushes arnt bad, get a push pull tool, one with the tubes etc and selection of threaded bar, I borrowed one from mechanic and did both over a weekend, both sides upper and lower, could have cracked on and done all in 1 day. With that tool there really not hard.
Last edited:
RangeRoller dt
Well-Sprung Member
- Posts
- 14,393
- Location
- Trapped inside my head @ LZ asylum
Is that the one came from your dads?
- Posts
- 33,600
- Location
- North Shropshire
Yep that's it
Brakes and clutch bleed are the next job then it should roll
stuu
Well-Known Member
- Posts
- 1,946
- Location
- Aberdeenshire
I wish, just a powersteering pump
- Posts
- 19,297
- Location
- Buckinghamshire, UK. ('95 DT)
You could have stopped for a pint!
brianp38dse
Well-Known Member
- Posts
- 20,062
- Location
- heathrow
We went passed on the main road i did think about it but it was getting late and i needed some dinner
i gave it full monty up the Ammersham hill toward Beconsfield a brick that size should not go up there that fast
- Posts
- 19,297
- Location
- Buckinghamshire, UK. ('95 DT)
i honestly though my 4.4 tdv8 would be much more economical than the 4.0 v8 in the p38
how wrong i was
You don't get power for free. You can either have an economical car or a powerful one. There's only so much you can do with variable valve timing and flaps and so forth.
- Posts
- 19,297
- Location
- Buckinghamshire, UK. ('95 DT)
We went passed on the main road i did think about it but it was getting late and i needed some dinner
i gave it full monty up the Ammersham hill toward Beconsfield a brick that size should not go up there that fast
I bet the trip computer doesn't go low enough to show consumption up that hill WOT. It'd probably need a negative sign for the Rangie.
Datatek
Well-Known Member
- Posts
- 44,883
- Location
- Near Poitiers SW France
Perhaps the display could change to "gallons per mile"
Obviously owners of these oversize, overweight, overcomplicated overpowered gas guzzlers are not believers in man made climate change
brianp38dse
Well-Known Member
- Posts
- 20,062
- Location
- heathrow
It did drop it a bit we got 18mpg there and back, he has had it up to 23 on a slow run to Henton
