- Posts
- 16,358
- Location
- Benfleet, Essex
I went out driving in the pouring rain to see how much water leaked in from the sunroof.
So far, so good. Will check tomorrow too.
So far, so good. Will check tomorrow too.
What did you do with your Range Rover today
- Thread starter Dopey
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 19,297
- Location
- Buckinghamshire, UK. ('95 DT)
I never use them so I wouldn't worry about it.
stuu
Well-Known Member
- Posts
- 1,946
- Location
- Aberdeenshire
Went out drove it about some tracks i found.
- Posts
- 33,600
- Location
- North Shropshire
Been out for a longer drive to Chester.. buggrit.. coolant pîssing out 
need to tighten the new hose to the water pump in the morning
need to tighten the new hose to the water pump in the morning
- Posts
- 33,600
- Location
- North Shropshire
Hope it just needs tightening and isn't a bad signBeen out for a longer drive to Chester.. buggrit.. coolant pîssing out
- Posts
- 4,653
- Location
- Rotherham
- Posts
- 33,600
- Location
- North Shropshire
Hope so and also hope it doesn't all drain into the road overnight!! I haven't got any more antifreezeDon't fret cause it is
- Posts
- 4,653
- Location
- Rotherham
- Posts
- 33,600
- Location
- North Shropshire
Sod that!!!Couple of bottles of vodka instead
- Posts
- 4,653
- Location
- Rotherham
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
How did you tell? Was it the colour? It pi$$ed down all day until it turned to hail.Been out for a longer drive to Chester.. buggrit.. coolant pîssing out
- Posts
- 33,600
- Location
- North Shropshire
It stopped here! And no hail!!How did you tell? Was it the colour? It pi$$ed down all day until it turned to hail.
- Posts
- 33,600
- Location
- North Shropshire
Definitely needed tightening, that's crap britpart rubber hoses that go soft and loose shapeHope it just needs tightening and isn't a bad sign
Pressured to 10psi, found another weep, sorted that and topped up, hopefully all good again
Datatek
Well-Known Member
- Posts
- 44,887
- Location
- Near Poitiers SW France
I see you took the precaution of having a rescue car escort you
- Posts
- 33,600
- Location
- North Shropshire
Well, i can see regular bubbles in the expansion tank but on the other hand it doesn't seem to be over pressurising and there's no further leak that i can tell.
I've run it up to temp and done a few miles in 3rd to keep the revs high, then let it stand idling for 10 mins. Top hose isn't rock hard.
but on the other hand it doesn't seem to be over pressurising and there's no further leak that i can tell.I've run it up to temp and done a few miles in 3rd to keep the revs high, then let it stand idling for 10 mins. Top hose isn't rock hard.
- Posts
- 4,653
- Location
- Rotherham
See we were right. A good tight un and all will be wellDefinitely needed tightening, that's crap britpart rubber hoses that go soft and loose shape
Pressured to 10psi, found another weep, sorted that and topped up, hopefully all good again
- Posts
- 33,600
- Location
- North Shropshire
It's still blowing bubbles and the level isn't dropping, doesn't seem to gain undue pressure thoughSee we were right. A good tight un and all will be well
- Posts
- 4,653
- Location
- Rotherham
Does it need another burp?
- Posts
- 33,600
- Location
- North Shropshire
Possibly
- Posts
- 4,653
- Location
- Rotherham
