RustyDefender
Well-Known Member
- Posts
- 567
- Location
- Lake District
What did I mess up on here?
- Thread starter RustyDefender
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 7,877
- Location
- East Midlands
In my case there wasn't enough room once the bolts holding the stub axle on were tightened. Hence the need to cut some metal away.
If the driveshaft isn't sticking out far enough to get the spring clip on, there's usually a hole in the end of them with a screw thread, so you can put a bolt in and pull it out. Usually I find that just hooking something into the threads and giving it a tug does it.
If the driveshaft isn't sticking out far enough to get the spring clip on, there's usually a hole in the end of them with a screw thread, so you can put a bolt in and pull it out. Usually I find that just hooking something into the threads and giving it a tug does it.
RustyDefender
Well-Known Member
- Posts
- 567
- Location
- Lake District
Yeah that didn’t even work. I even bought the right bolt and tried pulling on that. No movement outwards
Dr Strangeglove
Well-Known Member
- Posts
- 705
- Location
- Lancashire
I really was in the same situation, even bought the bolt! Took it apart and reassembled it and it went together OK. I can't remember what meshed but it did!
- Posts
- 7,877
- Location
- East Midlands
It's really hard to tell what might be fouling without coming to have a look at it with you and you're miles away. What I do is take bits off one at a time and see what component is responsible for the binding, and look at things to see where they've been touching. Looking at all the new bits compared to the old ones can be informative so you can see where they're thicker or thinner, longer or shorter etc.
