Freelander 1 Wet carpet

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
dog-man said:
All stripped down now and ready to mop out the lake that I found there (between rear seat foot area and front pedals only on drivers side)
I do think at the moment I have two leaks, one front one rear.
Never seen so much water inside a car except for one being retrieved from a river. :D

Still not 100% sure of how it got in.

I put some sealant under the roof bar fittings just in case.

A cup of tea and then some serious mopping out then if I can get the extension cable I lent to my son who then unknown to me lent it to a friend back today, I can attempt to dry it out with a powerful fan heater.
Over my Christmas break I shall have to get the wife to run a hose over various parts of the car whilst I am inside watching for a leak.
Click to expand...

Dust the floor and side walls with talcum powder and look for the tracks ...
 
I have had to abandon removing the carpet.
The only way to remove it would be to cut it at the very front under the heater area as some things go through the carpet, rather than the carpet being cut to go around them.
So it's back to the heater for now.

I need to use the car tomorrow and Tuesday then have 14 days off, so I will put the heater and a dehumidifier in for a few days then.
 
I think I might try and get some cardboard to put under the carpet in the hope it absorbs some of the water from the sponge backing of the carpet.

Does anyone have any other ideas of what to use to try and suck up the liquid from the sponge backing?
I might upset the wife and use our towel supply. :)
I will explain that it's and emergency.
 
dog-man said:
I think I might try and get some cardboard to put under the carpet in the hope it absorbs some of the water from the sponge backing of the carpet.

Does anyone have any other ideas of what to use to try and suck up the liquid from the sponge backing?
I might upset the wife and use our towel supply. :)
I will explain that it's and emergency.
Click to expand...

Hire a wet vac ..
 
Just had an idea of where the water may be coming from.

Not so long ago, I replaced the rear drivers side door window regulator.
I wonder if I didn't reseal the door properly?

I shall concentrate on that area first when pouring water over the car to find the leak.
 
OK, I believe I am getting closer to finding the source of the leak.
Looking in the drivers door, down to the right just below where the bonnet opening lever is.
There is a load of wiring and next to that an opening in the bodywork which has foam in the opening.
The foam was soaking wet and the lower part was sticking out of the opening into the cab and it seems that water was dripping down close to the accelerator pedal.
I have pushed the foam all the way inside the opening as it seems to supposed to be there and not a bodge job to stop a leak.
So, where would the source of the water be that runs down to this opening and is the foam supposed to be a barrier to stop it entering the cab?
I find that hard to believe.

Hopefully, I can attach a photo.......

 
I can't be sure that it did actually rain last night but the area under the foam was completely water free this morning.
We have heavy rain forecast tomorrow, so will check it again tomorrow.
 
It looks like I am right so far, but I am waiting for the heavy rain later today to prove or disprove my theory.
We have only had light rain. I know I could use a hose but have been busy doing Christmassy stuff.
Will concentrate on the car from Sunday onwards.
 
my wife has solved mine she remembers us going through a very deep puddle and she has dried it out and while I was I hospital having my new knee she kept an eye on it no more water in the car and we have had lots so when I am a bit better I will be looking as the door seal at the bottom blood useless things
 
So the wet patch is only under the drivers seat. Mmmmmmmm

You sure this isn't what you need.
B004Q8FF9I_pampers_201304183_4627_lg_zpsfqysw99i.jpg
 
Damn, my secret is out. I already wear them. :D

Well, despite promised heavy rain in every weather forecast, it has not happened, so I have had to deploy the hosepipe.
It does look at the moment that I have found and cured the leak. It does seem to be the sponge that was hanging slightly into the cab and dripping.
I used the talcum powder suggestion and cannot see anymore water entering the cab.
So now the drying process begins in earnest.
One powerful fan heater and a dehumidifier.
Must be costing me a fortune for electricity but it has to be done.
 
well we thought we had found out ours was letting in through deep puddles but it was dry last night but this morning after heavy rain last night mine was soaking so back to the drawing board but we are sure it has something to do with the door seal.
 
Friend of mine had wet carpets on his bmw ,it was eventually traced to the membrane on the door being split, water was working its way through ,this sometimes happens if door panel has been off as it often gets damaged ,hope this is of some use . ps he had already replaced the door seal but it still leaked .
Regards Trev
 
Niffty said:
Water in the box in the boot is nearly always from the rear door.
Above the door on the outside is a plastic trim that goes right across the back.
Prize off the two side trims as these hold the top trim in place, unclip the top trim and if the screws are not to rotten to remove, take them out.
Cover around the screw holes with sealer and put the screws back, just cover the screws if you cant get them out.
The factory fit stupid foam seals behind them screws, the foam rots away and in comes the water,
Its a simple fix thats far easier than stripping things down and taking carpets out to find bung holes etc.
Remember the side trims just pull off and the top trim unclips top and bottom
Click to expand...


I have tried to remove the two side trims by prising them off but they are not budging and I am wary of damaging them.
I am heavy handed and often break things.

Can someone explain exactly how they come off?
 
I had this issue about a year or so ago and it was the matrix, not sure if anyone has suggested this but if you get some white tissue paper blot the liquid and see if its coolant colour if not its your seals.
I had a look a a few how to things on doing it and it looked like a right **** of a job so I got some Kseal. I put a bottle of this in and it fixed it, heater isnt that good but it doesnt leak now although because the cars not wet it doesnt steam up that much anymore. The heater wasnt any worse for sealing it, heard loads of stories about how you shouldnt use kseal but it worked for me and engine is running fine still well over 200k miles now. Doesnt over heat.

My mate has a lotus with the kseries engine he used it 3 years ago now as the coolant was leaking, i think it runs through the chassis and he used it on his and again still fine, its really cheap worth a shot.
K-Seal.png
 
You must log in or register to reply here.

Similar threads

N
Major leak major electrical issues
Replies
2
Views
343
Nc225
N
M
2019 Discovery HSE TD6
Replies
0
Views
211
mapen100
M
MAF Diver
Disco 2 Nanocom/RAVE manual is wrong: adjusting windows after removing key and opening a door?
Replies
4
Views
429
MAF Diver
MAF Diver
dag019
Difference between hard top and station wagon roof
Replies
9
Views
388
julianf
julianf
M
My Freelander Passed with flying colours
Replies
4
Views
435
Atomician
Atomician
Back
Top