Waxoyl

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
M

MISSILE1

New Member
Posts
3
Location
ST ALBANS
Anyone know of a a good person / company who offer a Wayoyl service using Dinitrol - steam/pressure clean and application ?

I'm located in St Albans and looking to Waxoyl my 2007 Defender 90

Or any other suggestions

Andrew
 
Well I want to treat the underside of the vehicle , some people say Waxoyl and others say Dinitrol is a better product

I would be I interested to know people's thoughts

Thanks for the quick response
 
Please please don't anyone take this serious it doesn't work, it's the date that made me say it.. 1st Of April:D
 
RyanDay1 said:
Its the cleaning bit I'm after, need to get inventive
Click to expand...

I jetwashed more than once, the. Got underneath with a brush and water and then wire brush. I had a rust hole in one side so rinsed the inside of the chassis aswell (used cable hole in other side) was worried it would duck the wiring but it was fine) I then left it to dry for about 2 weeks in the summer then applied dinitrol 2 applications, into every book I could get in. Stuffed the bulkhead with loads.
 
flat said:
I jetwashed more than once, the. Got underneath with a brush and water and then wire brush. I had a rust hole in one side so rinsed the inside of the chassis aswell (used cable hole in other side) was worried it would duck the wiring but it was fine) I then left it to dry for about 2 weeks in the summer then applied dinitrol 2 applications, into every book I could get in. Stuffed the bulkhead with loads.
Click to expand...
How much rust converter did you use? The rejel kits only come with one 400ml aerosol is that enough? I already painted the rear 1/4 in converter paint as it cant wait until summer
 
RyanDay1 said:
How much rust converter did you use? The rejel kits only come with one 400ml aerosol is that enough? I already painted the rear 1/4 in converter paint as it cant wait until summer
Click to expand...

I didn't use much tbh, I wired brushed and used a brush on converter where needed - my chassis was quite good though - just surface rust in a few places that came out okay. Most of the rust converter spray went on the bulkhead footwells
 
You must log in or register to reply here.

Similar threads

saxosportsaxo
2011 2.4 Puma 110. Hesitating between 2400 and 3000 rpm
Replies
1
Views
735
nickc
N
1
Big Question
Replies
9
Views
1K
110Matty
1
styleruk
2.25 petrol rough idle
2 3 4
Replies
60
Views
2K
styleruk
styleruk
R
D2 V8, engine swap.
Replies
10
Views
2K
Stanleysteamer
Stanleysteamer
Freddie17
Kent laning 5th?
Replies
7
Views
1K
Freddie17
Freddie17
Back
Top