Washers

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
plumbfisher

plumbfisher

Active Member
Posts
523
Location
Berwickshire
(I'm trying here for 'most trivial enquiry' :eek: )

Where is the non return valve on the windscreen washers? The screen wash has just started to run back a bit so that I no longer get an immediate strong jet but a spluttery half hearted squirt. (There, that should get some comment from TC Alan! :D ) I'm thinking there must be a NRV failed or a bit blocked somewhere. Works ok second time.
 
Drivers side of bonnet. From front follow pipe to left from T off for drivers side jet, should be along there.

PS. How dare you suggest that my mate Alan would make anything like an unsavoury remark? :D:D
 
Last edited:
"Drivers side of bonnet. From front follow pipe to left from T off for drivers side jet, should be along there."

Thanks, found it. Typically though, its not somewhere handy, but is actually in behind and underneath the cooling fluid tank..
Now the usual challenge of repairing the un-repairable. Can I get a sealed plastic thing to bits without terminally knackering it? I'm going to try anyway :)
 
plumbfisher said:
"Drivers side of bonnet. From front follow pipe to left from T off for drivers side jet, should be along there."

Thanks, found it. Typically though, its not somewhere handy, but is actually in behind and underneath the cooling fluid tank..
Now the usual challenge of repairing the un-repairable. Can I get a sealed plastic thing to bits without terminally knackering it? I'm going to try anyway :)
Click to expand...

Just try blowing through it both ways should clear any ****e out. Or if you have a large syringe blast some water through it.
 
Yup, tried that. No joy. So levered the top off (its not sealed, just a push fit) to find little bit of crap stuck under the thin rubber diaphragm. All working fine again. Thanks! :)
 
plumbfisher said:
Yup, tried that. No joy. So levered the top off (its not sealed, just a push fit) to find little bit of crap stuck under the thin rubber diaphragm. All working fine again. Thanks! :)
Click to expand...

Cool, obviously my recommendation did not work cause it was crap causing the problem and not ****e. Must remember that one. :D:D:D
 
plumbfisher said:
It is important to get the terminology just right when dealing with technical stuff! :D:D
Click to expand...

Well, I must say I don't know where to start, what with a spluttery half hearted squirt, a good blow through to clear the ****e, levering it's top off, and crap under the diaphragm !! A wealth of innuendo and double entendre but at least you have full flow now, should get it really wet. :D:D
 
tomcat59alan said:
Well, I must say I don't know where to start, what with a spluttery half hearted squirt, a good blow through to clear the ****e, levering it's top off, and crap under the diaphragm !! A wealth of innuendo and double entendre but at least you have full flow now, should get it really wet. :D:D
Click to expand...

Fnarr! fnarr! thought you would enjoy that lot! :lol:
 
tomcat59alan said:
well, i must say i don't know where to start, what with a spluttery half hearted squirt, a good blow through to clear the ****e, levering it's top off, and crap under the diaphragm !! A wealth of innuendo and double entendre but at least you have full flow now, should get it really wet. :d:d
Click to expand...

QED!. :d

A
 
Last edited:
You must log in or register to reply here.

Similar threads

K
Car wash Damaged Windscreen Wipers
Replies
6
Views
1K
lightning
lightning
styleruk
2.25 petrol rough idle
2 3 4
Replies
60
Views
2K
styleruk
styleruk
S
2012 Disco 4 Just wont start.
2
Replies
28
Views
5K
Graculus
Graculus
Grrrrrr
P38A Brakes!
2 3
Replies
44
Views
4K
Ratae
R
J
300 Tdi engine swap story - and a few questions
Replies
13
Views
2K
doriz
doriz
Back
Top