Washer pumps
- Thread starter Yorkie57
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
discool
Well-Known Member
- Posts
- 13,659
brian47
Well-Known Member
- Posts
- 8,867
Apart from the diagrams, this might also have some bearing on the subject:-
Headlamp power wash. (from the workshop manual in RAVE)
Headlamp power wash activates when the following conditions are met:
Headlamp power wash. (from the workshop manual in RAVE)
Headlamp power wash activates when the following conditions are met:
- Ignition switch in position II.
- Headlamps switched on.
- Front windscreen wash switch operated.
- BCU counter allows headlamp power wash. I think that this is set by default to every 3 operations of the windscreen wash the headlights wash once.
Bennehboy
Well-Known Member
- Posts
- 2,215
- Location
- Huddersfield
Also needs to be enabled in BCU if retrofitting.
discool
Well-Known Member
- Posts
- 13,659
What model of D2 doesn't have head lamp washers then?
Landmark2
Well-Known Member
- Posts
- 810
- Location
- Shropshire
Hi Yorkie,
If you haven't done so already, download the LR manual known as RAVE (mentioned in an above reply) Has all you need.
HTH,
Griff
If you haven't done so already, download the LR manual known as RAVE (mentioned in an above reply) Has all you need.
HTH,
Griff
I have had the same issue and its driving me nuts. Rear washer not working. New pump fitted. Not working. Checked old pump on a spare battery and its fine. Should have tried that first but hey ho. If I swap over the plugs on the pumps, the windscreen switch then works the rear pump. So ordered a new dash switch for rear washer. Still not working...
To access yours. Take off the nearside front wheel. Remove the plastic panel to get access into the rear of the front bumper, and washer bottle with both pumps is right there. You might have a problem removing the three Philips head screws on the inside turn of the bumper. Mine were rusted in solid.
To access yours. Take off the nearside front wheel. Remove the plastic panel to get access into the rear of the front bumper, and washer bottle with both pumps is right there. You might have a problem removing the three Philips head screws on the inside turn of the bumper. Mine were rusted in solid.
sierrafery
Well-Known Member
- Posts
- 18,032
- Location
- Arad/Romania
check fuse F30 interior fusebox...should have been your first move even if it's not blown
Last edited:
Similar threads
