CHRIS HILL
Active Member
- Posts
- 111
- Location
- CHESTERFIELD
Hia. Ive got a bad vibration coming from underneath my 300tdi disco. can also feel it through gear stick. anybody able to point me in the right direction?
vibration
- Thread starter CHRIS HILL
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Trewey
Cockernee, Pasty munchin bastid.
- Posts
- 20,088
- Location
- Kernow - Near England
My money would be on yer Prop UJs.
G-man
BBQ king
- Posts
- 12,065
- Location
- essex.... in the middle somewhere
thats a bloody silly place to keep your money! safer than a bank but not as good as under yer mattress tho
Toad
Active Member
- Posts
- 202
- Location
- Orkney Islands
I have a 1994 300 Tdi that I have recently put a new front prop shaft on because I had a severe vibration coming from under the car. The shaft has a slight telescopic action on it to allow for the movement of the axle. In my case this telescopic action had completely seized and with there being no give in the shaft it just about shook the car to bits.
Unfortunately I had already gone down the route of replacing my UJ's thinking this may correct the situation, but it didn't solve the problem, replacing the shaft completely did.
- Posts
- 83,282
- Location
- Embasinga stocæ
DV is the donut king 
.
.
robint
Well-Known Member
- Posts
- 7,057
DV is the donut king
amongst a few other small problems that unfortuntly seem only to happon to him
CHRIS HILL
Active Member
- Posts
- 111
- Location
- CHESTERFIELD
Thanks for the help. Changed ujs today. Checked prop to make sure it wasnt seized. The vibration has got worse! Is there a spring inside the handbrake handle? The button on mine is stuck inside. you can poke it out but as soon as you push it in again it stays in. Started happening today when i was test driving at changing ujs.
Trewey
Cockernee, Pasty munchin bastid.
- Posts
- 20,088
- Location
- Kernow - Near England
You didn't pull yer propshaft apart at the splines did you?
CHRIS HILL
Active Member
- Posts
- 111
- Location
- CHESTERFIELD
No. Dint know it came apart.
Toad
Active Member
- Posts
- 202
- Location
- Orkney Islands
Thought I'd mention a problem I had some 20 years ago that I had on a 110. It also caused vibration and it wasn't until you mentioned the handbrake that it came back to me. It turned out that my handbrake was binding and it was most evident when I dipped the clutch. I had the handbrake serviced and hey presto it did the job. Before it was seen to though the vibration was terrible and the hotter the brake got the worse the vibration was. If I remember rightly the underlying problem was the gunged up linkages on the handbrake mechanism that weren't allowing the brake to release properly.. Hope this helps.
CHRIS HILL
Active Member
- Posts
- 111
- Location
- CHESTERFIELD
Thanks will take off the handbrake tomorow and have a look.
