ming
SPACE TWOT
- Posts
- 11,977
- Location
- PLANIT ZOG
Well earthling it pends really [everyone has there own method]. . . .so this is mine fer wvo, i course filter using a stainless fine mesh into a bucket ,then use one leg of a pair er Mrs Ming's tights [yer dunt have to wash em ] attach to a large funnel at bottom [spout ] using a cable tie to hold it on spout un pour through funnel int a nuther bucket , this will get rid of most the ****e [chuck the tights ] then your ready fer the chemical bit , i use a titration measure kit orft e bay to get the correct figures for the process , i heat it using an old water boiler to 80 deg [this gets rid of most water,but not 100%] after the process i used to run it through absorba beads [stuff they use for mopping up oil spillage in garages] then filter to 10 microns using a pump through a big cartridge stainless filter [these are hard to get] i run it through for about 1 hour, the last part is a pain. . . .thats where the centrifuge comes in , never try ed that before so i don't know if its better , however my end results using last method is good[clear bio] but still a pain. . . . .Is it best to filter the oil before adding the methonol/spirits or would it be easier to filter it afterwards (as it will be thinner)
I'm guessin once it's thin enough all the crap will settle to the bottom anyway?