P38A Unrepairable EAS fault after side steps fitted?

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Update on my situation.
All springs are now replaced and pumped up.
Not losing air it seems now.
I made some ride height calibration blocks from a sawn up broomstick. Will do to get approx heights and fits nicely into the bumpstops.
Still getting EAS Fault, both rear sensors, same message. Going to check the connections again and see what I can find.
Still on schraders. Maybe now just move back to the valve block......

Cheers
 
Update on my situation.
All springs are now replaced and pumped up.
Not losing air it seems now.
I made some ride height calibration blocks from a sawn up broomstick. Will do to get approx heights and fits nicely into the bumpstops.
Still getting EAS Fault, both rear sensors, same message. Going to check the connections again and see what I can find.
Still on schraders. Maybe now just move back to the valve block......

Cheers
If you are getting sensor faults, have you checked the wiring and connectors?
 
If you are getting sensor faults, have you checked the wiring and connectors?
That is the next job. Back to the sensors. All seemed ok until I had actually bolted them in place. Must have disturbed something...... Job for next week. Off to Supercharged Saturday at Silverstone for tomorrow.
 
Back
Top