kermitlandy
New Member
- Posts
- 9
- Location
- France
Any ideas? All the fluid has thrown out, presumably from the dipstick, now showing empty, vehicle still starts. Discovery 1998
Transmission fluid throwing out dipstick
- Thread starter kermitlandy
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
On my '98 Discovery the dipstick tube had fractured where the small bracket is to bolt the tube to the block. Looked like it had been welded before. Managed to sleeve it cos I couldn't get a new one, then supported it on top. Seems like the tube vibrates a lot, but on mine it only leaked on start up. Fine after it had been running, no leaks at all then.
blue beasty
Leaks an prone to bits dropping off
- Posts
- 63,107
- Location
- Gloucestercotshirewolds
No idea about the set up but worth checking breather
kermitlandy
New Member
- Posts
- 9
- Location
- France
All been washed off, new fluid, drove it, returned to house kept it running, when pressure built up definitely coming out of dipstick, enough to loosen the cap, new fluid now all over the ground !!
Your thoughts please, thanks.
Your thoughts please, thanks.
blue beasty
Leaks an prone to bits dropping off
- Posts
- 63,107
- Location
- Gloucestercotshirewolds
Still sounds like a blocked breather
kermitlandy
New Member
- Posts
- 9
- Location
- France
Hi Blue Beasty, thanks for your replies, other half says "how the f.... do you get at them"
thanks
thanks
blue beasty
Leaks an prone to bits dropping off
- Posts
- 63,107
- Location
- Gloucestercotshirewolds
No idea
Most latter boxes have a banjo bolt with a 6mm pipe fitted running along the top of the box and up the bulkhead but as for anything vehicle specific after 1984 I don't know.
Someone will or try a search on here or Google.
Jimbof
New Member
- Posts
- 1
- Location
- Perth, western Australia
Mines doing the same, bloody auto gearbox I can never get the correct level and I have over filled it. I found the breather on the passenger side of the car at top right of the box, I pulled the pipe out which was on top of the gearbox not up the bulk head, it had melted at the end and was really restricted, I cut the end of a routed it to a better place. It's still ****ing fluid out but I will drop the lot tomorrow and re do. Check your breather pipe banjo has not blocked or the pipe has melted and the box is not breathing. I have seen pics of the dip stick tube with air filters in allowing the box to breathe. Hope you find the cause.
