Tracking

boycie · Mar 20, 2015

Hi Folks I am going to get a new set of tyre's fitted on my P38 next week .I normally get them to check and adjust the wheel alignment at the same time on our over cars, is there any particular setting that the suspension should be set on when they check and adjust the the P38 ?. I did not know what effect (if any) the panhard rod would have on the axle alignment on the higher settings .

Rob Edge · Mar 20, 2015

Normal road height.

boycie · Mar 20, 2015

Thank you .I kinda thought that would be the case but its nice to get it confirmed by someone that know's for sure .

zzr1200 · Mar 20, 2015

Just out of interest, toe out/in (by how much ) or parallel?

I'm hopefully replacing my track rod assembly this weekend, if I get the time.

wammers · Mar 20, 2015

zzr1200 said:
Just out of interest, toe out/in (by how much ) or parallel?

I'm hopefully replacing my track rod assembly this weekend, if I get the time.

Parallel to 1/16" toe out. Never toe in on a driven wheel.

zzr1200 · Mar 20, 2015

wammers said:
Never toe in on a driven wheel.

That can depend on if its a full time or part time 4x4.

wammers · Mar 20, 2015

zzr1200 said:
That can depend on if its a full time or part time 4x4.

Would think parallel would be the setting for part time driven axles.

Tracking

boycie

Active Member

Rob Edge

Repairer of scratches and scrapes.

boycie

Active Member

zzr1200

Well-Known Member

wammers

No longer with us, RIP

zzr1200

Well-Known Member

wammers

No longer with us, RIP

Similar threads