blue beasty
Leaks an prone to bits dropping off
- Posts
- 63,117
- Location
- Gloucestercotshirewolds
tools
- Thread starter pinkpussy
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 10,639
- Location
- Oxfordshire
he wouldn't be a newbie then.. would he?
pinkpussy
Banned
- Posts
- 14
- Location
- Peoples republic of Islington
Just getting changed before going into work 12.30 - 03.30. For those that volunteered info thanks.
By the way I am allmost unshockable.
Back tomorrow
By the way I am allmost unshockable.
Back tomorrow
Oldfogey
Active Member
- Posts
- 285
- Location
- Pembrokeshire
Back to the original question.
A bottle jack will certainly do the job, is the lightest option, and the cheapest. But it can be difficult to place, and more unstable in less than ideal conditions.
A trolley jack is heavier to lift out of the vehicle, but easier to position, as it is on wheels and can be shoved around by the handle. Of course it takes up more room in the vehicle.
Go into Halfords and have a look at the options, see what they weigh and how big they are. Check that they have enough lift to raise you vehicle.
If you are worrying about the weight of things, however, the weight of the wheel may be your biggest problem. Try lifting the spare down and see what I mean. Worse than that is when you are trying to put it on the studs and have to lift it quite precisely. Try it out on the drive before you have to do it for real.
I don't know how well the impact driver will work (again, try it out now), but I like to have a socket and a good long arm to lever it with, say 3ft, not the little ones in socket sets.
Also have in your kit a small tarpaulin to lie on, perhaps a kneeling pad, gloves, wipes for removing mud and oil from yourself, and one of the plastic covers garages put over the seat to keep it clean.
In case all that fails - pack the lap-dancing kit. Guaranteed to get the wheel changed almost instantly!
A bottle jack will certainly do the job, is the lightest option, and the cheapest. But it can be difficult to place, and more unstable in less than ideal conditions.
A trolley jack is heavier to lift out of the vehicle, but easier to position, as it is on wheels and can be shoved around by the handle. Of course it takes up more room in the vehicle.
Go into Halfords and have a look at the options, see what they weigh and how big they are. Check that they have enough lift to raise you vehicle.
If you are worrying about the weight of things, however, the weight of the wheel may be your biggest problem. Try lifting the spare down and see what I mean. Worse than that is when you are trying to put it on the studs and have to lift it quite precisely. Try it out on the drive before you have to do it for real.
I don't know how well the impact driver will work (again, try it out now), but I like to have a socket and a good long arm to lever it with, say 3ft, not the little ones in socket sets.
Also have in your kit a small tarpaulin to lie on, perhaps a kneeling pad, gloves, wipes for removing mud and oil from yourself, and one of the plastic covers garages put over the seat to keep it clean.
In case all that fails - pack the lap-dancing kit. Guaranteed to get the wheel changed almost instantly!
winchman
Active Member
- Posts
- 746
The V8 man
Well-Known Member
- Posts
- 1,951
- Location
- Redhill Surrey
Well i dont know if the 110 has the same standard bottle jack as my disco but with the slightly cranked bar across the top they work perfectly fitting under the axle, they work very well and are easily stored in the car, good for general lifting but as said before dont get under it without extra safety like axle stands ok
pinkpussy
Banned
- Posts
- 14
- Location
- Peoples republic of Islington
thanks for all the good advice just bought 4 ton bottle jack with cradle adaptor type thingys in carry case from local motor factor. Impact tool is a Milwaukee for the person who asked
wack61
Well-Known Member
- Posts
- 3,623
- Location
- Warrington Cheshire
Pink pussy has not made any friends
I can't see that lasting long
Whatever Jack you get make sure it's secured behind the seat, you don't want a big lump of metal flying about in a crash
I can't see that lasting long
Whatever Jack you get make sure it's secured behind the seat, you don't want a big lump of metal flying about in a crash
easye1
Banned
- Posts
- 8,557
or just buy the 2 biggest bottles of puncture repair and inflator plus a 12 volt compressor to top up the tyre pressure.
not intended for permament repairs but gets you out of the ****e and on your way to a real tyre repair shop..
most new cars dont have spare wheels these days, just a tiny bottle of jizz,
.... er, did I just say that in here....
not intended for permament repairs but gets you out of the ****e and on your way to a real tyre repair shop..
most new cars dont have spare wheels these days, just a tiny bottle of jizz,
.... er, did I just say that in here....
b20wnx
Well-Known Member
- Posts
- 1,077
- Location
- wakefield west yorkshire
You need a trailer to carry everything useful, my suggestion is get good breakdown cover or wear short skirt, low cut top and you have em queuing to help out
biggeeeee
Retired - Living the dream
- Posts
- 11,090
- Location
- Lanarkshire or Argyll
brian47
Well-Known Member
- Posts
- 8,867
Any portable impact driver (or any other such portable electrical device) is only as good as the charge in the battery, and I can almost guarantee that when you need it the battery of your Milwaukee will either be flat or still at home on the mains charger.
Nice try though.
- Posts
- 10,639
- Location
- Oxfordshire
:lol:
Oldfogey
Active Member
- Posts
- 285
- Location
- Pembrokeshire
OK, You've got the kit - now put the car on the drive, jack it up, take a wheel off and put it back on again.
Seriously, you do not want to be doing this for the first time in the rain at the side of a busy road. You may well have done it before on a smaller car, but now you have a Landy, and the big wheels really do make it harder. Had a puncture a week ago, and though I am experienced and reasonably strong, it is still hard work.
Then let us know how you get on.
Best of luck.
Seriously, you do not want to be doing this for the first time in the rain at the side of a busy road. You may well have done it before on a smaller car, but now you have a Landy, and the big wheels really do make it harder. Had a puncture a week ago, and though I am experienced and reasonably strong, it is still hard work.
Then let us know how you get on.
Best of luck.
Rusty Spanner
Active Member
- Posts
- 231
ooo ehh.......... A pink pussy looking for tools
There's only one tool for a pink pussy ....... and this is probably the place you'll find one
There's only one tool for a pink pussy ....... and this is probably the place you'll find one
ooo ehh.......... A pink pussy looking for tools
There's only one tool for a pink pussy ....... and this is probably the place you'll find one
Dead serious like http://m.youtube.com/watch?v=JPtQ4K-evBo
Those compressors and cannisters of glue are a nightmare!! Maybe fine if just a nail or screw but good for #### all else- got a puncture driving home last month (14 plate zafira) went the boot, attached compressor, glue all over the road as tyre had a 2 inch split. Ended up waiting in car for over an hour for rac with two screaming kids and one moaning wife. And all after 7 hours christmas shopping- was not impressed! If I'd had a spare (even a space saver one) I'd of been on my merry way in about 10 mins. Useless!! Rac guy recons it's all about saving weight for eu emissions!
Rant over, sorry.
Rant over, sorry.
