Temp gauge

Henry_b · May 1, 2020

Only difference between the 1997 and 2001 is they used Green gauges and a "slightly" different graphic..

Wiring is the same IIRC.

Grrrrrr · May 1, 2020

I prefer the early dash!

wammers · May 1, 2020

If there is no power to the sensor lead the problem will more than likely be in the BECM. The sensor lead feeds the BECM and the BECM feeds the gauge.

Rover drive · May 1, 2020

Henry_b said:
Only difference between the 1997 and 2001 is they used Green gauges and a "slightly" different graphic..

Wiring is the same IIRC.

Ok thank you
Sorry what’s IIRC

wammers · May 1, 2020

Rover drive said:
Ok thank you
Sorry what’s IIRC

If i recall correctly.

Rover drive · May 1, 2020

wammers said:
If i recall correctly.

Haha whoops thanks

Datatek · May 1, 2020

Check for wet carpet and underlay in the footwell, if it's damp, it might well be a corroded connector on the BECM.

wammers · May 1, 2020

Look at connector C106, 13 pin black connector under expansion tank, clean contacts on that. Pin 8 (green wire) is the connection, sensor to BECM.

Rover drive · May 1, 2020

wammers said:
Look at connector C106, 13 pin black connector under expansion tank, clean contacts on that. Pin 8 (green wire) is the connection, sensor to BECM.

Thanks
Mate sent me that tip earlier
I have just finished checking that,
It appears it could be there, as connecting and disconnecting that connector makes needle move to end of blue.
So I will clean properly

Rover drive · May 1, 2020

Off topic
A member sent me a message offering to use their nanocom
I hope you are reading this and thank you.
I wasn’t being rude and not replying I just can’t see where on here that has the message
I got an email notification
Thanks

brianp38dse · May 1, 2020

Messages or conversations come up it top right hand corner if you have a message the envelope goes red , click on that.

Rover drive · May 2, 2020

brianp38dse said:
Messages or conversations come up it top right hand corner if you have a message the envelope goes red , click on that.

Thank you, I found it

Temp gauge

Henry_b

Think outside, no box required.

Grrrrrr

Technician, Bodgit & Scarper Ltd

wammers

No longer with us, RIP

Rover drive

Member

wammers

No longer with us, RIP

Rover drive

Member

Datatek

Well-Known Member

wammers

No longer with us, RIP

Rover drive

Member

Rover drive

Member

brianp38dse

Well-Known Member

Rover drive

Member

Similar threads