Disco 2 TD5 fuel strainer - how much???

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
J

joojar

Active Member
Posts
158
Location
Derbyshire
Getting parts together to change FPR next week, but going rate for MAE100010 seems to be (drum roll) 60 to 70 squids

Thinking I'll just clean up and re-use the existing one, any reason that's a bad idea?

(And 60/70 squid - what the.. ?)
 
Yes I've been there, it is made from metal mesh so only needs washing in solvent blow it dry and re fit with a new o ring.
Take care when you take the regulator housing off at that point my strainer disappeared never to be seen again.
 
raywin said:
Yes I've been there, it is made from metal mesh so only needs washing in solvent blow it dry and re fit with a new o ring.
Take care when you take the regulator housing off at that point my strainer disappeared never to be seen again.
Click to expand...
Makes sense - thanks raywin
As it happens, I'm changing the inlet manifold gasket at the same time, so hoping it'll be somewhat less fiddly with the better access
 
joojar said:
Makes sense - thanks raywin
As it happens, I'm changing the inlet manifold gasket at the same time, so hoping it'll be somewhat less fiddly with the better access
Click to expand...
Should be much easier, but I would still put an old washing up bowl or something under the engine, just in case, I took the regulator off and cleaned it down then went back to take out the strainer and it was gone forever, sounds crazy and I searched for hours but it was lost, it was certainly there because I saw it when I removed the regulator.
Oh how I laughed.
 
James Rogers said:
Have you checked the furthest possible place away from where you dropped it? Its usually there...
Click to expand...
I checked all over the place becoming increasingly more angry and belligerent, but it did me no good hard to believe that it could disappear into a black hole but it did, I still wake up at night screaming, but nothing like I did when I started to look up the price of a new one.
I was very lucky actually a very kind LR owner had a spare one knocking around in his garage and sent it to me I am eternally grateful to him.
But take care don't fall into the same trap put something there to catch it and take it out carefully, it is only held in by the o ring and can go into free fall as soon as the pressure regulator is removed.
 
mine fell out but got trapped on the suspension arm the 1st time. the second was on the back of the starter motor. Oh the fun I had finding it
 
gazman said:
mine fell out but got trapped on the suspension arm the 1st time. the second was on the back of the starter motor. Oh the fun I had finding it
Click to expand...
So why does it come out spontaneously? Does it flush out with little bit of fuel that's in the head?
 
You must log in or register to reply here.

Similar threads

mad85
Disco 2 TD5 Low Fuel pressure!!
2
Replies
22
Views
592
mad85
mad85
stumpyj
Fuel Line worn through
Replies
2
Views
578
stumpyj
stumpyj
Bustrucket
Disco 2 Td5 Overheating
Replies
3
Views
775
johnlad
johnlad
stumpyj
(2000 TD5 90 defender)TD5 Fuel Pump
Replies
4
Views
329
stumpyj
stumpyj
Sieklo
Disco 2 TD5 Fuel line green fitting on the pump popping out
Replies
6
Views
1K
tilly2
T
Back
Top