Got an issue with the parking sensors on my 52 plate discovery. Now I know there are no diagnostics for this system so fault finding is quite difficult.
basically ignition on and in reverse long beep and flash on parking sensor switch. Got out and listened to the parking sensors for the clicking and one wasn’t clicking so replaced it with a genuine sensor.
Same issue after fitting except the new sensor clicks at a slower rate than the other 3. Switched with one of the other sensors and the slow click follows the new sensor.
This indicates to me that all the sensors have good wiring connections and the issue is the new sensor. So should all the sensors be calibrated the same or do I need to replace all the sensors?
basically ignition on and in reverse long beep and flash on parking sensor switch. Got out and listened to the parking sensors for the clicking and one wasn’t clicking so replaced it with a genuine sensor.
Same issue after fitting except the new sensor clicks at a slower rate than the other 3. Switched with one of the other sensors and the slow click follows the new sensor.
This indicates to me that all the sensors have good wiring connections and the issue is the new sensor. So should all the sensors be calibrated the same or do I need to replace all the sensors?