TD4 Stuck in light mud/grass

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Hi Richard,

This is why I asked the question as to which Freelanders have TC - as I thought they all did. Hippos says he thinks it was initially an option for a couple of years.

When I switch on, the TC warning light comes on for a few seconds - as a check.

I would imagine if a car didn't actually have TC then the warning light would not illuminate.

There are several warning lights that on my car do not light up as I don't have that option - for example 'seat belts not fastened' is one. I think that light only operates in the USA and Canada.

My TC light very very rarely comes on when I'm driving on the road - coming out of roundabouts in ice and snow conditions usually.

Off-road is a different matter - never seen it on grass though - only on muddy rutted uphill tracks.

S.
 
Last edited:
Hi rhodie does your hippo feel tight when you turn full lock @ low speed or full lock reverse.........also how long has our second VCU been in place.
 
Hi rhodie does your hippo feel tight when you turn full lock @ low speed or full lock reverse.........also how long has our second VCU been in place.
been on a few mounths now, there is a little tightness in reverse on full lock
but that is normal for freelanders.
first one thay sent me in may last year there was no tightness no rear drive nothing. now when on the mud/wet stuff all 4 wheels can be spun.
i wonder if thay new thay had a prob and then when people complaind, thay sent out good ones.
i guess time will tell..
 
well that's a bit odd.

early mark 1's must have a different suggested psi from facelift models but I assume they are the same weight/ tyre specs.

either way 34 psi is too much!

I believe LR lowered the recommended pressures after loads of folks complained of tyres wearing in the middle of the tread.

Of course it could have been caused by insufficiently high cornering speeds. :D :D ;)

I've overtyred mine by having wider tyres, higher speed rating and slightly higher load rating - I run at 26psi and the tyres wear evenly, the fuel consumption is unaffected, and the road-holding is improved.

I think that at 34psi you would have an uncomfortable, bumpy journey.
 
Hi I knew this would cause controvsy - I have used this for ages tyres fitted at 108k I am now on 129k no noticable wear in the middle ......... I think I get away with this as the tyres are std 15 inch 80 aspect they have pretty big side walls they are the Hankook At tyre they are brilliant. If you have the lower profile jobbies I think you would maybe have issues with your teeth falling out!
 
Hi I knew this would cause controvsy - I have used this for ages tyres fitted at 108k I am now on 129k no noticable wear in the middle ......... I think I get away with this as the tyres are std 15 inch 80 aspect they have pretty big side walls they are the Hankook At tyre they are brilliant. If you have the lower profile jobbies I think you would maybe have issues with your teeth falling out!

I agree with you completely - if the tyres are not wearing abnormally then all is well. And your right about the difference in profile too - 34 on mine would make them far too hard - as it is they are quite flexible. 26 in yours and they might look like you had a puncture.

All is well in tyre land - no controversy - just different. :D

Singvogel.
 
Nope! If I remember correctly , when first released they specified 26psi but this was then adjusted to 30psi due to tyre wear and handling characteristics.
I wouldn't run 34psi on my tyres as at £200 a corner wearing the centre tread out early would **** me right off.
At 30psi as stated In the hand book I get at least 35k(thousand miles) out of a set of tyres.....my rears lasted until 45k........although I did swap the wheels round and put the newest tyres on the rear.
 
This talk of tyres and psi levels is all well and good but have you got your VCU sorted out yet since that's the source of your problems.
 
Back
Top