TD4 Starter motor removal.

C

CJK

Member

Posts

96

Location

Stockport, Cheshire

• Jan 29, 2011

• #1

Trying to get the starter motor out - it is being a pig.
Cannot get the top bolt undone!
Can anyone enlighten me - is this top fixing a nut and bolt on the back - as per the lower fixing, or does the bolt tighten into a threaded hole.
Trying to remove from the top of the engine only without removing undertray and working from below!
Thanks.
Chris.

 

pardec

Active Member

Posts

993

Location

South Manchester- North Devon

• Jan 29, 2011

• #2

CJK said:

Trying to get the starter motor out - it is being a pig.
Cannot get the top bolt undone!
Can anyone enlighten me - is this top fixing a nut and bolt on the back - as per the lower fixing, or does the bolt tighten into a threaded hole.
Trying to remove from the top of the engine only without removing undertray and working from below!
Thanks.
Chris.

Click to expand...

Did mine a few months ago, it was a tw*t to get out.

The top one on mine was just a bolt, accesed from the gear box side. It's a tight squeeze, Get your hand in between the gearbox and all the pipesand you shoulf feel it. I used a 6 inch exstension bar.

 

C

CJK

Member

Posts

96

Location

Stockport, Cheshire

• Jan 29, 2011

• #3

Thanks, I have found it, it is just stupidly tight!
Sheared off a 1/4" drive rachet trying to undo the top bolt, hence the thought that could be a nut behind it too....
Think it has started to round off as well..
Chris

 

joe27979

Well-Known Member

Posts

1,354

Location

west Norfolk

• Jan 30, 2011

• #4

there's a great walkthrough step by step guide in Land Rover Owner magazine this month ;0)

 

C

CJK

Member

Posts

96

Location

Stockport, Cheshire

• Jan 30, 2011

• #5

Thanks - I shall go have a look..

Chris

 

B

bonnybrook

Active Member

Posts

424

• Jan 30, 2011

• #6

Did mine few year ago - yes it's very tight. Make sure you get good quality sockets that fit well or it will round off and cause you a nightmare.

Mines the auto - and initially i undid the wrong bolt (must have been holding the gearbox on!), you can't see it but should be able to feel it with your hand. Remove the battery box gives good access. I recall I used a breaked bar and extension to shift it.