Freelander 1 Tailgate Rubber Seal

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
andyfreelandy

andyfreelandy

Well-Known Member
Posts
5,604
Location
Devon
I have a perfect condition tailgate seal on a scrap vehicle. I want to reuse it.

Has anyone worked out how to dissolve the adhesive mastic at the top in order to get it off the metalwork without ripping the seal?

Thanks.
 
No experience myself, but a friend was recently doing some work on some old machinery that had a LOT of old grime on it, including what looked like old glue and silicone. He used this stuff, along with a plastic scraper, and swore by it…

shop.ct1.com

MultiSolve 500ml

MultiSolve is a complete new multi-purpose solvent for the safe removal of adhesives, sealants, oil, grease, silicon, wax, tar, paraffin, printing ink etc.
shop.ct1.com shop.ct1.com
 
andyfreelandy said:
Exciting !! Thanks.

With new seals at around £300 got to be worth investing £11.

Cheers.
Click to expand...

Certainly worth a shot, see if it frees it up.

Meths works well on removing the stickiness of old school plain mastic (such as found round windows), but reckon you need more chemicals for the adhesive side.
 
Screenshot_20241017_182355_eBay.jpg
 
Have you tried a heat gun?

I use this at work for removing old stuck on seals, softens the adhesive.

Might be worth trying it on 1 you don't want to keep first in case it damages the seal more than the adhesive!
 
I think warm is good, melted rubber is not so good ! The mastic is under the seal and holds it firm to the paintwork. Going to be difficult to get solvent in there. Maybe a hypodermic and inject into the sealant.
 
andyfreelandy said:
I think warm is good, melted rubber is not so good ! The mastic is under the seal and holds it firm to the paintwork. Going to be difficult to get solvent in there. Maybe a hypodermic and inject into the sealant.
Click to expand...
I don't get the heat gun to close, just enough to soften it, worth having a go on a scrap 1, the seal material might cope well with a bit of heat.
 
Done it.

Heatgun on metal work which didn't ruin the paintwork anyway.

Thin scraper and bent screwdriver to run under the rubber as it was warmed up.

Must not kink the very top line as it is aluminium and difficult to straighten. I did a bit but got away with it !!

Clean up with solvent and then fitted to vehicle using UPOL Tiger Seal. Clamped in place nice and tight while sealant goes off.

Looks good. Will it be water tight now ???
 
You must log in or register to reply here.

Similar threads

D
Freelander 2 (LR2) Freelander 2 tailgate
Replies
4
Views
658
J_D
J_D
L
Relay location for tailgate
Replies
5
Views
1K
xDParis64
xDParis64
The Cumbrian
Freelander 1 Tailgate WindowI have
2
Replies
26
Views
977
Alteredtech
Alteredtech
A
Freelander 2 (LR2) Tailgate opens when I open the driver door
Replies
2
Views
477
Nodge68
Nodge68
M
Mark 1 Tailgate glass.
Replies
2
Views
382
andyfreelandy
andyfreelandy
Back
Top