L322 Suspension fault
- Thread starter joejoe300
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
gold rover
Well-Known Member
- Posts
- 10,296
- Location
- dùthaich Dhè fèin
I will start by saying I am not the most techy type. Any possibility of the wiring leading to the sensor having been chafed? Is sensor facing the correct way. No offence but it has been known to happen. Have you cleared the fault and tried again?
Some of the more techy type will be along soon
In the meantime, maybe pop along to the Introduction thread and say hi to everyone
Hi thankyou for your comment yes I have made sure its fitted the correct way with the arm facing out I have deleted the code and it comes back up it's got dynamic suspension I got the suspension to go up when for a drive and the code came back up and it dropped the suspensionI will start by saying I am not the most techy type. Any possibility of the wiring leading to the sensor having been chafed? Is sensor facing the correct way. No offence but it has been known to happen. Have you cleared the fault and tried again?
Some of the more techy type will be along soon
In the meantime, maybe pop along to the Introduction thread and say hi to everyone
gold rover
Well-Known Member
- Posts
- 10,296
- Location
- dùthaich Dhè fèin
Well that's me out, on all but the wire. Not sure who to tag but will start with @backinblack
- Posts
- 6,243
- Location
- North Manchester
Not played with dynamic suspension but may be worth checking the voltages on the sensor to make sure you have the 5v feed and earth. Can you see the voltages on the diag tool?
Hi all just had a look at the voltage at the top of the dynamic strut tops on the front both read 0.88 volts
Then I have done a ride level control module diagnostics interface
And the following readings
Left front corner height -103
Left front height sensor voltage 4.68 v
Right front corner height -99
Right front height sensor voltage 0.47 v
Left rear corner height-43
Left rear height sensor voltage 1.58
Right rear corner height-53
Right rear height sensor voltage 3.12
Pressure 306 kpa
Pressure sensor voltage 0.81
Motor temperature 20 c
Compressor temperature 18c
What do you all think to this
Then I have done a ride level control module diagnostics interface
And the following readings
Left front corner height -103
Left front height sensor voltage 4.68 v
Right front corner height -99
Right front height sensor voltage 0.47 v
Left rear corner height-43
Left rear height sensor voltage 1.58
Right rear corner height-53
Right rear height sensor voltage 3.12
Pressure 306 kpa
Pressure sensor voltage 0.81
Motor temperature 20 c
Compressor temperature 18c
What do you all think to this
- Posts
- 6,243
- Location
- North Manchester
Did you recalibrate the suspension when you changed the sensor?
Is the car sitting level or is high/low on different corners?
Those voltages for the front sensors are way to far apart to be right.
Is the car sitting level or is high/low on different corners?
Those voltages for the front sensors are way to far apart to be right.
|
- Posts
- 6,243
- Location
- North Manchester
When you measure from the centre of the wheel to the wheel arch are all 4 corners the same?
