fatblokexl
New Member
- Posts
- 52
- Location
- Newtyle, Angus, Scotland
I replaced my VCU bearings earlier this year ( bought from Foundry 4x4 and fitted by local garage) as there was a constant rumbling noise when moving.
Not so long afterwards i noted a similar but greatly reduced noise.
The landy would only have done 1-2k miles at most in this time.
The noise is present in all forward motion, ignition on or off, freewheeling or under drive, it doesnt increase/decrease in pitch or volume. There s no change when cornering that i have noticed.
Is it possible the bearings have failed again and so soon?
Is there a likely cause for them to fail so quickly?
Not so long afterwards i noted a similar but greatly reduced noise.
The landy would only have done 1-2k miles at most in this time.
The noise is present in all forward motion, ignition on or off, freewheeling or under drive, it doesnt increase/decrease in pitch or volume. There s no change when cornering that i have noticed.
Is it possible the bearings have failed again and so soon?
Is there a likely cause for them to fail so quickly?
