Supercharged 2.25p

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Turboman said:
If you buy a Detroit locker, and fit it in your own diff, they aren't actually a lot of money. You can sometimes get them, or ARBs, second hand, sometimes already installed in an axle. Look around on the net.

I doubt if any of those will be as expensive as supercharging a Series engine, and your engine is more likely to survive.
Your vehicle will also hold it's value as well.
Click to expand...
Hmmm okay I will look in to it Thnks!
 
AlexCampbell said:
Hmmm okay I will look in to it Thnks!
Click to expand...
If you want to buy new Detroit stuff, look for an Eaton Transmissions agent round you. In your location, that will probably be a bus company or garage that does other stuff too, and they might have second hand bits as well, or know who does.
If you have one, a local Land Rover club might also advise you.
 
chrisstdt said:
I should think that would be a good way to blow up the engine and / or gearbox and snap half shafts !
Click to expand...
Lol. Why do people post shot like this?

it’s not as if nobody in the past 50 years has had the thought to fit a V8 or T-Series turbo engine to a Series……

The 2.25 was also turbocharged from the factory in the form of the 2.5 Diesel Turbo. So the basic block is certainly capable of boost. And there are even a few 2.5p turbos kicking about I believe.
 
kermit_rr said:
A properly tuned SU carb will make a big difference, if you can get one
Click to expand...
Big difference no. Unless you fitted one to an I’ll running engine. But then that is gains from making it run right. The SU will offer some gains in some areas though I do agree. But the gains are going to pretty insignificant. Especially vs a booster engine.

Also no reason why you can’t run a blower with carbs. Loads and load and loads of people do it every single day with a huge variety of engines and types.
 
300bhp/ton said:
Also no reason why you can’t run a blower with carbs. Loads and load and loads of people do it every single day with a huge variety of engines and types.
Click to expand...
I thought you needed a specially modified carb that was aware of boost, so you're not running lean when it's running or rich when it's off
 
I think the supercharging bit has been done before either on the series 2 forum or as a kit when the vehicles were current as an aftermarket option
As said fuelling will be your main issue, engine should be tough enough
 
If you are on budget, I wouldn't be supercharging it. It might seem like a cheap option but trust me, it won't be. The gearbox can't take too much more than 100bhp anyway. If you want more power but are on a budget, save up for the SU carb and mounting parts, and watch some YouTube vids on porting/polishing heads. Electronic ignition may help too, compared to the poor quality of points currently available. These will give you a definite improvement.
 
You must log in or register to reply here.

Similar threads

NowayPedro
Series 3 Red top pattern fuel pump pressure
2 3
Replies
43
Views
3K
Anaconda
A
L
Series 3 petrol trouble shooting
2
Replies
32
Views
2K
lcdck
L
dominicbeesley
2.25 exhaust manifold with 2.5 inlet
Replies
0
Views
1K
dominicbeesley
dominicbeesley
SNOman
How to: de-ASBO my old V8
2 3
Replies
44
Views
3K
6pot
6pot
styleruk
Weber replacement
Replies
16
Views
2K
Turboman
Turboman
Back
Top