Disco 2 Sump removal question
- Thread starter berg450
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
discool
Well-Known Member
- Posts
- 13,609
Is that engine or auto gearbox + type of engine? Just remove anything thats in the way and gives u ease of access prop can stay There isn’t a gasket as such as sealant is used as a seal between the two faces if its an engine sump.
Feathers McGraw
Well-Known Member
- Posts
- 2,780
- Location
- Cumbria
Can leave the prop on but you will need to lift the front up so the suspension is as extended as far as possible to give enough wiggle room to pull the sump out. Just make sure it's safe.
Replace the oil pump bolt, if its a TD5, whilst its off. I did use a gasket on mine, plus some RTV, where the manual says to do so.... As said, you need to jack up the body,not the suspension, to gain the room to get the sump pan out from under the engine.
Thanks for the answers guys. Job done yesterday. I had enough room to remove and put back the sump. Was easy without the gasket (when I made some trials) but when the gasket was on it was a pain.
It is difficult to keep the gasket in position especially when you do it alone laying on your back under the car
About 2 years ago I already done this job while I changed the oil pump bolt but the gasket went on wrong which caused a slight leak.
I can just hope it will be fine now.....
It is difficult to keep the gasket in position especially when you do it alone laying on your back under the car
About 2 years ago I already done this job while I changed the oil pump bolt but the gasket went on wrong which caused a slight leak.
I can just hope it will be fine now.....
Similar threads
