Sub frame

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Looking to swap rear sub frame on freelancer 2 is this a straight forward job and how long to under take this cheers dave

Easy as eating cake I would imagine, it's only nuts and bolts isn't it, not like you gotta fabricate a load of stuff up or repair a ton of rot before you can get on.

PS, digger dave, are you a digger driver or what?
 
Must admit to not being at all up on diggers myself, but shown some interest after watching them at work on the site next door (where a building was demolished), I googled one of the models named above 'Case EX180D'...... not a digger in sight. had more success with the Volvo however. :D

Certainly a skill possessed by the drivers I've been watching, like an extension of their arm/hand...impressive
 

Attachments

  • upload_2019-9-4_18-33-55.png
    upload_2019-9-4_18-33-55.png
    134.4 KB · Views: 108
Last edited:
Anything nice or run of the mill volvo/case/hitachi?

I got a Volvo EC140E currently, had a Case EX180D before that, miss the Case, nice big machine with Leica iCon 3D GPS machine control, it was magic :)
Started at the bottom on a Hymac been through the rest over the years got to say found hitachi one of my favourites but I will go with you on Volvo king of the diggers
 
Must admit to not being at all up on diggers myself, but shown some interest after watching them at work on the site next door (where a building was demolished), I googled one of the models named above 'Case EX180D'...... not a digger in sight. had more success with the Volvo however. :D

Certainly a skill possessed by the drivers I've been watching, like an extension of their arm/hand...impressive
Oops, my bad, it's a CX not EX :oops:

download (8).jpeg


Vign_photos_pelle_case_ws1038746110.png
 
Back
Top