jwaldron
New Member
- Posts
- 284
- Location
- YNYS MON (North Wales)
my spare is loose anyway as the holder part has come off... anyone make then (it will need welding into the boot floor) as I have a hole!
Strange noise from right rear
- Thread starter Henrik97
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
the hooded claw
Well-Known Member
- Posts
- 1,743
- Location
- Fleetwood Lancs, Besides the Sea!!!
DO NOT buy a "Spare wheel holder" ...go to the local Builders merchant & buy a length of 6mm threaded bar (Comes in 1 metre lengths) 2 Nuts & a hand ful of washers ..+ bout 1 metre of 4mm ply board
Thread the bar up thru the hole, measure & cut...... nut & washers on the end (Under the car) nut & washers inside car (at bottom of Wheel well) place wheel over bar sticking up, cut ply to same width as wheel & drill a hole in it at the centre place ply on threaded bar down to top of spare wheel washers & nut to tighten.....
SORTED!!!!!!!!!!!!!
Totalr cost ..Bout 6 quid
Pikey
Dummy Ejection Facilitator..
- Posts
- 47,185
- Location
- in Baron Wet Bum's Slave pit..
What if his butler is ****e at DIY?? or refuses to get his hands dirty???
jwaldron
New Member
- Posts
- 284
- Location
- YNYS MON (North Wales)
Sounds good... I'll have a look at doing it.
the hooded claw
Well-Known Member
- Posts
- 1,743
- Location
- Fleetwood Lancs, Besides the Sea!!!
You'd be surprised just how many times I've bin asked where I got "that length of threaded bar" ...( use it all the time fer hanging C/H pipes in commercial premises)
You'd think no ****er had heard of it .... (Comes in real handy havin a "3 FOOT BOLT" sometimes !!!)
