Still not going??

Chaser said:

So since changing the maf there are no fault codes is that right? or haven't you rescanned...

Click to expand...

It hasnt been rescanned since the new MAF no!

Does this fault have to be cleared from the ECM, before i can atempt
start/run?

Greenie said:

It hasnt been rescanned since the new MAF no!

Does this fault have to be cleared from the ECM, before i can atempt
start/run?

Click to expand...

NO. . . .just dissconect maf to see if it werks

Greenie said:

Does this fault have to be cleared from the ECM, before i can atempt
start/run?

Click to expand...

don't know for sure, i'm old school, before on board diagnostics.
check with your diagnostic guy and assuming it's not costing the earth i think i'd have it rescanned anyway in the hope it will give us something new to focus on.

I read an old thread earlier (can't find it again) something about inlet hoses collapsing internally causing a blockage/restriction.

only other way forward would be if someone near to you would allow you to try a few bits from their freelander until you find the fault.

Chaser..

ming said:

NO. . . .just dissconect maf to see if it werks

Click to expand...

Wot av i godda do that fer ming, its a noo wun!!:smokin:




Hope porkys ok, its long way tu go on ya own!! hope iz oxigun dunt
run oot!!:whoosh: