Hi, I have a 1.8 freelander (04 plate) I’ve previously been told it has a heavy clutch, which Would normally only affect 1st and 2nd gear and could be alleviated by pumping the clutch before starting the engine. However while driving the other day I felt it click under the pedal and it got really difficult to put into gear (all gears). Anyone got any ideas what could have gone? Thanks
Stiff gears Freelander 1.8
- Thread starter Mich86
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Stuart hall
Active Member
- Posts
- 385
- Location
- Lanzarote
Probably the complete hydraulic system which I believe can only be replaced as a single unit IE master, slave and all pipework as one.
Could be just where the slave pushes on the clutch, not as daunting as it sounds.
I'm sure if I'm wrong the learned one's will answer shortly.
Could be just where the slave pushes on the clutch, not as daunting as it sounds.
I'm sure if I'm wrong the learned one's will answer shortly.
freelance
Well-Known Member
- Posts
- 8,685
- Location
- essex and beyond
But don’t fit new system, until you have made sure clutch actuating lever is nice and free where it passes thro bell housing, which is probably your problem, the click you heard is either the bracket cracked and bent which holds slave cyl.
or the circlip broke in the master
or the circlip broke in the master
Stuart hall
Active Member
- Posts
- 385
- Location
- Lanzarote
Is the hydraulic system expensive freelance ? Got a feeling mines going. Hard to select gear especially when changing down. Pump pedal twice goes in easy. No probs usually when changing up.
tlo
Active Member
- Posts
- 558
- Location
- nottingham
https://www.jgs4x4.co.uk/freelander/freelander-1/axles-transmission/
On my sons the plate that held the cylinder was rusted and that had to be changed as well
Just make sure you get one from a good manufacture ,the link I posted is to give you a rough idea of how much they cost
On my sons the plate that held the cylinder was rusted and that had to be changed as well
Just make sure you get one from a good manufacture ,the link I posted is to give you a rough idea of how much they cost
