Steering Relay Oil

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Citizen Kane said:
My vote goes to the pre loaded taper roller bearings, much like you have in the pinion in the diff. Deep groove ball bearings are not best suited to this rocking motion and have limited load carrying capabilities compared to a roller bearing..
Click to expand...
I think I would go for taper bearings too, shimmed with a bit of pre-load, I reckon about 4 thou would do the job, same as the main bearings on a Velocette motorcycle.
 
If you are planning on welding the dumb iron it may be worth getting some penetrating oil down the side of the steering relay to make it easier to pull out. They rust in and get imposible to remove so its worth pulling it out while you have access and greasing everything.
 
rob1miles said:
If you are planning on welding the dumb iron it may be worth getting some penetrating oil down the side of the steering relay to make it easier to pull out. They rust in and get imposible to remove so its worth pulling it out while you have access and greasing everything.
Click to expand...
What he said ^^^^^^^, notoriously badly rusting into the perforation of the chassis, and yes I believe it could have rusted into a hole in the housing, the missing oil must be going somewhere.
The upside is, the soaking of the oil might make the relay housing easier to get out, mixed blessings.
 
You must log in or register to reply here.

Similar threads

G
2.25/2.5 Diesel Oil Pumps ?
Replies
2
Views
342
grewth
G
G
Oil pressure switch thread ?
Replies
2
Views
211
grewth
G
R
Overdrive very stiff?
Replies
4
Views
395
Wildefalcon
W
S
Series 3 Loud knocking sound from the engine when running.
Replies
12
Views
362
steve2286w
steve2286w
Ekenoos
I am starting to think that servicing the ol landy is more of an adv than off roading it
Replies
7
Views
636
Ekenoos
Ekenoos
Back
Top