Steering box drop arm nightmare

A

agew

Active Member

Posts

549

Location

The Chilterns

• Oct 4, 2018

• #21

I was leant a mega mega puller designed for the job, with 1m extension bar (would hate to think what torque it was pulling), plus the 'clout both side of the taper' worked fine in the end........ Swearing helps a lot naturally..... Enjoy, A

 

G

Grebby

Active Member

Posts

296

Location

Sutton Coldfield

• Oct 4, 2018

• #22

He's probably managed to sort it by now. The post is 5 years old and the OP hasn't been seen on here for 4 years.

 

raywin

Well-Known Member

Posts

3,808

Location

North Yorkshire

• Oct 4, 2018

• #23

Grebby said:

He's probably managed to sort it by now. The post is 5 years old and the OP hasn't been seen on here for 4 years.

Click to expand...

Blimey time flys when you are having fun.
He may still be under there f'ing and blinding.

 

ogb

Active Member

Posts

289

Location

Moray, NE Scotland

• Oct 11, 2018

• #24

Grebby said:

He's probably managed to sort it by now. The post is 5 years old and the OP hasn't been seen on here for 4 years.

Click to expand...

Yep -good point. Only got involved 'cos my local "wheel aligner" used a LOT of heat on my steering bits when doing the tracking. I wasn't happy and it cost him 2 hours labour and a new set of tre's and rod.

 

A

agew

Active Member

Posts

549

Location

The Chilterns

• Oct 12, 2018

• #25

T’was encouragement for Musicman’s weekend project rather than the OP....! Cheers, A