- Posts
- 83,287
- Location
- Embasinga stocæ
I think it is a round 2 pin plug about 10mil in dia with a D shaped mating section. I will take a pic tomoz.
Steep learning curve
- Thread starter resto_d1
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 83,287
- Location
- Embasinga stocæ
This is what the connector looks like....
Ignore the yellow wires.
I think the colours of the wires are blk/Grn and blk
Ignore the yellow wires.
I think the colours of the wires are blk/Grn and blk
Yes and one has been snipped - I didn’t snip it. I labeled it with a ? As didn’t remember unplugging it from anything and try to label up everything
- Posts
- 83,287
- Location
- Embasinga stocæ
Try and repair it, if you can find the connector as well. Shout when you have rejoined it. 
- Posts
- 9,105
- Location
- Roaming the UK on assignments
That engine looks nice and shiny, a heck of a lot better than when I first saw it a couple of years ago lolz, it was hanging
You probably going to have evened out your weight in steel with having gotten rid of all that crud hahaha
You probably going to have evened out your weight in steel with having gotten rid of all that crud hahaha
- Posts
- 9,105
- Location
- Roaming the UK on assignments
Undo the set screws on that anti rattle catch and you can adjust that too.
Should lock an unlock on central locking remote. If not then buy a £20 kit an just use remote for back door lol
Should lock an unlock on central locking remote. If not then buy a £20 kit an just use remote for back door lol
@Hicap phill i can’t remember if you moved work but do you still have those rollers available do you know? Thanks
Hicap phill
Well-Known Member
- Posts
- 16,260
- Location
- Wiltshire
sorry moved jobs now
They cleared the site into skips so no rollers.
Screw fix do some nice ones(heavy duty) that are used on sliding draws/cabinets
after inspection the lock problem was clear. I seem to be running into feeble designs all the time!
The lock has come away from its seat in the rod, despite the securing pin being in the seat. This was due to the tiniest bit of plastic being broken. Litterally a mm thick.
I wasn’t paying 60 quid for a new lock just for that seat so ‘repaired it’....
Attachments
Hicap phill
Well-Known Member
- Posts
- 16,260
- Location
- Wiltshire
No idea Phil I can’t even shoot one straight. I’m actually getting lessons and hopefully license in the off season. Been beating on a shoot past season but would quite like to get atleast a half gun or working gun on a little syndicate at some stage. No rush though, probably focus on clays and a few pigeon shoots until I’m half a shot
Hicap phill
Well-Known Member
- Posts
- 16,260
- Location
- Wiltshire
My cartridges was sponsored by lyvale express when they were round the corner from parent in Birmingham (30years ago)
Used to get 2k carts a month to shoot.
Used to shoot for a living & teach on corporate days in Kent. That’s before they banned hand guns & job was lost
Get your licence application going it brings the cost down of your shooting as no gun hire & buy in bulk.
Used to get 2k carts a month to shoot.
Used to shoot for a living & teach on corporate days in Kent. That’s before they banned hand guns & job was lost
Get your licence application going it brings the cost down of your shooting as no gun hire & buy in bulk.
