Steel chequer plate?

MOB993

Active Member

Posts

143

• Mar 29, 2014

• #1

Hi found someone local selling sheets of 3mm steel chequer plating quite cheap and I will eventually need some to patch up my 110 and to protect the wing tops etc. Most chequer plating on offer for defenders seems to be aluminum. Will steel be better or no difference ? I know that steel will need to be painted to stop rust.
It's going at half the retail price.
Probably a stupid question but thought I'd ask so I don't get stuck with a sheet of the stuff and it no good to me... Cheers

 

blue beasty

Leaks an prone to bits dropping off

Posts

63,116

Location

Gloucestercotshirewolds

• Mar 29, 2014

• #2

Upside is steels a lot stronger. downside is it's a lot heavier.

3mm steel is a helluva slab to go sticking on wing tops. it's thicker than yer chassis wall

 

DieselDazzler05

Member

Posts

56

Location

Aberdeen

• Mar 29, 2014

• #3

would be ok for structural patches/repair sections but its a nightmare to cut,

I had some of the 6mm stuff and it was incredibly hard, took ages to drill and workwith

 

MOB993

Active Member

Posts

143

• Mar 29, 2014

• #4

Will I be able to bend it without a table for bending? Was gona use it in the footwell to cover the the floor up to the bulkhead. So just the one angle.

 

Dr_evil

Banned

Posts

29,535

Location

Perched on the naughty step

• Mar 29, 2014

• #5

no unless you slit it first

 

DieselDazzler05

Member

Posts

56

Location

Aberdeen

• Mar 29, 2014

• #6

That's gonna be quite wide, maybe mark it out and use a chunk of 2x2 running along the underside to prop it up, then use the landys weight to bend it

 

MOB993

Active Member

Posts

143

• Mar 29, 2014

• #7

On the inside of the bend I'm assuming? It's looking like it's just too much hassle. Prob better of buying a sheet of aluminum chequer plating instead.

 

MOB993

Active Member

Posts

143

• Mar 29, 2014

• #8

When I was thinking about how to cut it I found this vid of a handy device for a grinder.

Straight Cutting Metal With Abrasive Discs: http://www.youtube.com/watch?v=jTlzcDJqcWU can be picked up on eBay

 

MOB993

Active Member

Posts

143

• Mar 29, 2014

• #9

bathena21 said:

I had to alter the brackets

Click to expand...

What do you mean?

 

mlucas110

New Member

Posts

480

Location

christchurch dorset

• Mar 29, 2014

• #10

Its easy to bend we use it for some recovery trucks n bangers all the time! Cut a slice where you wanna bend it, wedge it between to longer bits of box Section in a vice and a nice pull and it bends lovely. You can always run a weld on the side you sliced to strengthen it back up