P38A Starting issue

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Now all I need is a bit of land and a gallon of petrol and some matches god give me strength here goes for the brains of the forum right checked all fuses 6&7 and 17 didn’t show a supply till I turned on the ignition when I pushed 6&7 with the probe I could hear the gearbox clicking then I wobbled the fuses and the two plugs into the dash binical and it started run for a short while then turned off and then nothing again re entered the eka code with nanocom and it started again and when moved fuses a bit the dash binical lite up again helps again please
 
pete12345 said:
Now all I need is a bit of land and a gallon of petrol and some matches god give me strength here goes for the brains of the forum right checked all fuses 6&7 and 17 didn’t show a supply till I turned on the ignition when I pushed 6&7 with the probe I could hear the gearbox clicking then I wobbled the fuses and the two plugs into the dash binical and it started run for a short while then turned off and then nothing again re entered the eka code with nanocom and it started again and when moved fuses a bit the dash binical lite up again helps again please
Click to expand...
Does the fuse box smell of burning?
 
pete12345 said:
Hi Alan I’m talking about the small box on seat no burning smell thou
Click to expand...
What about the main fuse box where the relays are? Can you make up a wire to fit on the small terminal on the starter solenoid and touch to positive on the battery,if it turns then you'll have to trace the original wire back, think it should end up in the connector under the expansion tank.
 
If it started after you messed with the fuses and binnacle plugs I would be giving them a clean and making sure the pins were all in properly and tight
 
Yer Alan main fuse box seems ok and the wire to solenoid is ok it started ok after I messed about with small box on side of seat Brian would the wires to the binical interfear with the starting issue
 
The seat fuse box is part of the becm and as the dash and almost everything runs through it, that would be a good place to start, might be worth taking it out and checking for any moisture damage
 
Quick update checked all fuses on becm again still no joy with it starting and fuse 6&7 and 17 no power to until ignition switched on but I can hear a clicking noise coming from the becm when I turn key to position 3 any suggestions much appreciated
 
From what i have read from Martyuk there are two boards in the becm a power board and a logic board, the logic one has all the info of the motor on and the power board can be swapped over keeping your existing logic board
 
Sounds bit daunting will contact Rick the pick and send it of to him I think it just seems strange that it started twice then nothing again
 
You must log in or register to reply here.

Similar threads

B
3.5 efi ignition issue
Replies
12
Views
921
norseman
norseman
L
Intermittent starting issue.
Replies
4
Views
398
Anaconda
A
F
P38A Starting issues.
Replies
7
Views
667
kermit_rr
kermit_rr
R
2000 Thor 4.6 fuel/starting problems
Replies
5
Views
407
richardtamps
R
K
L322 not starting
Replies
11
Views
2K
backinblack
backinblack
Back
Top