Archy1234
Member
- Posts
- 23
- Location
- Bedfordshire
Thanks. It is metal and split in half. I could try glue I suppose but will look for a replacement first.
Starter relay problem
- Thread starter Archy1234
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Flossie
Well-Known Member
- Posts
- 10,975
- Location
- Shropshire
I can't remember what the end of the ign barrel looks like. Can you post a pic? Can't find an image online.
New barrels arnt massively expensive but I would try a repair first, nowt to lose.
New barrels arnt massively expensive but I would try a repair first, nowt to lose.
Officerdibble
Member
- Posts
- 75
- Location
- Northwich
The end of my ignition barrel basically just had 4 electrical spade connections for the various positions on the ignition system
Flossie
Well-Known Member
- Posts
- 10,975
- Location
- Shropshire
That's the ign switch shown in the pic above, it's held to the barrel by two small self tappers, the ign switch is turned by the lock barrel but in the OP's case the barrel is broke and not turning the still serviceable ign switch.
Hicap phill
Well-Known Member
- Posts
- 16,201
- Location
- Wiltshire
But has he tried a screwdriver to see if it still runs
Them little collars break easily.
Later barrels I think this piece is missing & the rod goes straight into that hole.
Archy1234
Member
- Posts
- 23
- Location
- Bedfordshire
Hi AllBut has he tried a screwdriver to see if it still runs
Them little collars break easily.
Later barrels I think this piece is missing & the rod goes straight into that hole.
Another update. It fires up !!! It was the little collar. I managed to glue it back together and it seems to have worked. I can’t believe a tiny bit of metal could be so problematic. Just need to get the barrel back on and hope all the wiring in the dash is still in place. A big thanks for everyone’s help
I definitely didn’t have a clue where to begin until I asked you guys.
