Well after getting the 90 home and then jet washing it and finding all the holes and bodging that had been done to the chassis I have now started the strip down ready for a new galved chassis. Is there a gasket that goes at the top of the gearbox? Looks like a oil leak from the top.
started to strip
- Thread starter hilly01
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Defender-Sam
New Member
- Posts
- 358
- Location
- Burton Upon Trent
Glad I'm doing it now. Went round it all with a hammer and lots more than I thought. Also the front prop was changed just before I got it and all the bolts were hand tight.
sounds like your doing a good job, scary them loose bolts/bad workmanship moments I had a few when i was stripping mine.
AlbertDefender90
Active Member
- Posts
- 955
- Location
- Ellesmere, Shropshire
Mine was the same, look at my thread: 200tdi rebuild.
I think the gearbox leak is from the top again the same as mine.
I think the gearbox leak is from the top again the same as mine.
Cheers guys.
Will be calling Marshalls soon for chassis. Will do all brake pipes and rubber etc at the same time as I hope to be keeping it for some time to come ( I hope ).
I had to stop and think to myself did I undo the bolts and just forgot to carry on but I know I didnt so double checking everything on it now. Was the top of the box easy to do as I dont want to take the top off and things fly everywhere lol.
Will be calling Marshalls soon for chassis. Will do all brake pipes and rubber etc at the same time as I hope to be keeping it for some time to come ( I hope ).
I had to stop and think to myself did I undo the bolts and just forgot to carry on but I know I didnt so double checking everything on it now. Was the top of the box easy to do as I dont want to take the top off and things fly everywhere lol.
AlbertDefender90
Active Member
- Posts
- 955
- Location
- Ellesmere, Shropshire
I've not done it yet, but it is just a paper gasket underneath the top cover which I think comes off fairly easily. Is yours 300 or a 200 cos the gearboxes are different and I'm not sure about the 300 gearbox
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
no r380 doesnt use gaskets ,silicone sealant is good ,make sure mating surfaces are oil free with brake clean etc,oil will also be coming out under hi/lo lever too there is a gasket there but again silicone will do
Its a 1997 300tdi.
AlbertDefender90
Active Member
- Posts
- 955
- Location
- Ellesmere, Shropshire
In that case I don't know what's under the top cover if its an r380, I would have thought it would come off easily enough though
Looks like I,m going to find out tomorrow then lol. Will let you know if it did have any springs in it and if I have lost any.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
very similar too the lt77
AlbertDefender90
Active Member
- Posts
- 955
- Location
- Ellesmere, Shropshire
Just looked it up, the top cover should come off in one unit, as James says its similar to the lt77
http://www.retroanaconda.com/landrover/parts_books/90/5_gearbox_transferbox_p368-474.pdf
Looked at this also and looks like I,m going for it tomorrow after its been cleaned.
Thanks for the info guys.
Looked at this also and looks like I,m going for it tomorrow after its been cleaned.
Thanks for the info guys.
