Squeaky D2

Good Morning - I need to find some time to get under the car this week but I though I would look for some pointers from the knowledge of users here.

I basically have a metallic squeak when accelerating...it sounds a bit like when the brakes are getting old....but a month or so back I replaced the front pads,disks and calipers. Had an mot a week ago and the rears are fine.
It seems to be coming from the front area but it is hard to tell 100%
The squeak is only there when accelerating and goes away as soon as I come of the gas, also using the brakes makes no difference to the noise being there or not. It also seems to match road speed not engine speed.

A clip link is below and any pointers where to look first would be great....starts at around 10sec





Cheers

Morning,

First place I would start is by taking the aux belt off and turn each of the components inc tensioner by hand and see if anything sounds odd.
Make sure the crank / damper is not loose / worn.

Cheers

Hi Neilly - I will check that thanks

It all feels fine - and also wouldn't the squeak be more in tune with engine speed if it was an engine component....or am I being too simplistic in my view ?

I'm 90% sure it's your front prop UJ's fubard..... Get underneath and have a look.

robhew - you were right, got underneath and the front part of the front prop was moving abit - thankfully this is a job I have been planning for a while, so I had all the bits in the garage. Started last night and just finished. The centre bearing was a right cow to get out...in the end I had to grind a slot in the ball so I could get that out and then dig out the casing which took ages.

All done now though just need to take her for a drive

cheers

jimmies said:

robhew - you were right, got underneath and the front part of the front prop was moving abit - thankfully this is a job I have been planning for a while, so I had all the bits in the garage. Started last night and just finished. The centre bearing was a right cow to get out...in the end I had to grind a slot in the ball so I could get that out and then dig out the casing which took ages.

All done now though just need to take her for a drive

cheers

Click to expand...

The front part of the prop UJ was knackered? It's usually the rear of the front prop (The UJ's the double cardan end) that give up.

HTH