Special tool
- Thread starter Richsark
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
freelance
Well-Known Member
- Posts
- 8,685
- Location
- essex and beyond
Or look in a Sealey catalogue/ online
teddywood1
Well-Known Member
- Posts
- 5,558
- Location
- stoke-on-trent
I would use the hammer and either a screw driver which could damage the ring or a extension bar
Tonyj66
Active Member
- Posts
- 255
- Location
- Stirlingshire
A hammer and a piece of wood works well for starting it to move!
When it comes to refitting the pump. Locate the pump in its spigot (it only fits in one location). Then get a helper to push down on the pump really hard. This will compress the seal enough for the locking ring to locate on the threads. Then knock it round until it's tight.
td4van
Well-Known Member
- Posts
- 1,566
- Location
- Gloucestershire
Fit the seal to the tank and then insert the pump - makes the job a lot easier
- Posts
- 58,170
- Location
- Preston Lancs.
Here ya go and cheap as chips. https://jlrequipment.service-solutions.com/en-GB/Pages/ItemDetail.aspx?SKU=310-118
CJK
Member
- Posts
- 96
- Location
- Stockport, Cheshire
I will second fitting the seal to the tank, then fit the sender unit. Tried really hard, with lots of swearing, just couldn't get the thread started. Fitted seal to tank first - dead easy.
Hammer and screwdriver worked for me!
Chris
Hammer and screwdriver worked for me!
Chris
