sloppy steering / MOT

My landy has developed a really loose steering wheel, When i turn there is a good few inches play either way before it actually turns the wheels. What can I do about this? Its up for its MOT and i was also wondering what points i should really check over before putting it through its test?? Its a P-reg 300tdi. The rear x-member is corroded as well, will this affect the MOT? I only have an arc welder so I'm a bit dubious about trying to fit it myself so will it be best to take it to a professional? Thanks

if you can't figure out why yer steering is loose you'd best not start thinking about doing yer own x member

Open the bonnet, turn on the engine. Get someone to turn the steering wheel while you look at the steering shaft as it comes out of the bodywork.

What you are looking for is no play between the steering universal joints and the steering box. The amount that the steering wheel is turned should be the same at the steering rod and the steering box. If travel is lost between there, suspect the universal joints, there are 3 on the steering shaft wiggle each one in turn to feel for play. If this is all ok go on to the next stage.

Jack up the front of the vehicle so the wheels are clear of the ground, get your asistance to turn the steering while you look under and up into the engine bay. What you are looking for is delay in when the steering is turned, and the start of movement in the steering gear. Watch for movement at the steering drop arm ball joint first, then at the track rod ends both sides. Check the panhard rod for movement as well, this could indicate worn bushes.

As stated, your steering problem could be caused by one or more of the above it is a simple case of checking each item in turn.

The steering box can cause symptoms as you describe but this would show up in other ways as well, such as graunching noises and vibration.

I would not atempt to do the crossmember unless you are really competent as it is quite involved.

Drop arm ball joint. See Buster's manwell on it!

more like to be the steering UJs - has buster done them yet ?

Thanks for the help. I'll get someone who knows what they're doing on the x-member, I do a lot of towing so need to be sure its safe. Thanks again

odenne said:

Drop arm ball joint. See Buster's manwell on it!

Click to expand...

Sean said:

more like to be the steering UJs - has buster done them yet ?

Click to expand...

50p?