Series 3 speedo cable

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
T

T-C

Member
Posts
71
Location
Suffolk
Hi everyone,

I’m having issues with getting my speedo cable to work. The one on the car when I got it was snapped so I replaced this with a Britpart one. I refitted this multiple times as it would disconnect from the gearbox/speedo after about 10 yards. I’ve given up with the Britpart cable and got a Bearmach cable.
I thought I got this connected but it didn’t work. I opened the dash again and the cable wasn’t even near the speedo. Turns out the Bearmach cable isn’t clipping in and can just be pulled off? Any tips for getting it to clip in or have I got yet another bad cable?
 
Why was the britpart one coming out? Are the britpart and bearmach clips the same? Can you use the clip off the britpart one on the bearmach one. If one is not right send it back.
 
wireman said:
Why was the britpart one coming out? Are the britpart and bearmach clips the same? Can you use the clip off the britpart one on the bearmach one. If one is not right send it back.
Click to expand...
The Britpart cable inner part appeared to be too short. You’d drive a bit and then it comes out of one of the ends. The cables have different clip designs so I can’t swap the clip over.
 
T-C said:
The Britpart cable inner part appeared to be too short. You’d drive a bit and then it comes out of one of the ends. The cables have different clip designs so I can’t swap the clip over.
Click to expand...
Send them both back, or ring the supplier and tell them the problem, the britpart one sounds badly made, the bearmach one might be for a Series 2 which I think had a different fitting to the speedo.
 
How have you fitted it should come out from gearbox then back over gearbox bell housing clipped tp the D plate of gear lever mounting. If you buy a LH drive one it is physically longer and gives more option on where you locate it.
 
I got this worked well
2F0239C0-C39C-49F8-969B-D69693EBB75F.png
 
Thanks for the advice everyone. Dad fitted it while I was out. He took it off the gearbox and and lined it up to the speedo better. The inner was trying to go into the speedo head at an angle stopping the connector going on all the way.
 
You must log in or register to reply here.

Similar threads

C
snapped speedo cable Disco 1
Replies
14
Views
1K
Curly Oak
C
D
Is this a fuse on the negative?
Replies
8
Views
830
Doogal Too
D
awkwardbob
L322 2003 HSE radio connectors
Replies
4
Views
631
awkwardbob
awkwardbob
B
Disco 2 Xyz switch? Cranks but won’t start.
Replies
9
Views
1K
Bilbobagend
B
EmilH
Hello to all......
Replies
9
Views
2K
yfo866
yfo866
Back
Top