Series 3 rear shock fixing

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Hi, as an update I have uploaded a picture of the offending article.As you can see it's not in bad nick and has no signs of ever having split pin holes.
I presume the four were fabricated by the last owner, Dean
 

Attachments

  • thumbnail_20191125_114304.jpg
    thumbnail_20191125_114304.jpg
    196 KB · Views: 150
How tight is the rubber bush when pushed on the post? If the lower part of the shocker can be twisted when fitted in place between the two rubbers with the washer and pin in place it is an MOT failure. Quick fix is thicker washer.
 
I think I can see where the split pin went in .about a quarter of an inch in and in line with the spring bracket. polish it up with emery strip and you will see it then just drill it out and fit with new split pin and washer
 
Does anyone have the correct lenght for the pin? Then we can see if its been sawn off or not. If not then the pin hole should be there to be found.
 
Got a set in the garage will check later.
Could not find spare ones but got mat out and measured on Landrover overall length from back of inner bush to end of pin 21/8" length to split pin centre 17/8"
 
Last edited:
You must log in or register to reply here.

Similar threads

L
Rear Step Bolts?
Replies
5
Views
278
Lucy46
L
M
Newbie in market for LHD Series 3, need advice
Replies
8
Views
468
saxavordian
saxavordian
baldygit
Clutch Fitting Series 3
Replies
4
Views
519
norseman
norseman
I
Series 3 Diff Pinion Spacer
Replies
7
Views
455
steve2286w
steve2286w
Kingshill-Rover
Series 3 LWB in Buckinghamshire - Front Springs
Replies
11
Views
933
Rangieman123
Rangieman123
Back
Top