major truma 2
New Member
- Posts
- 525
- Location
- rotherham
well done mate ,,
if u dont mind ,,how much did u pay for it ?
if u dont mind ,,how much did u pay for it ?
series 3 lightweight
- Thread starter Chris W
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Chris W
Well-Known Member
- Posts
- 2,311
- Location
- Manchester
Wesley Pegden
Well-Known Member
- Posts
- 1,158
- Location
- Somercotes, Derbyshire.
grand .....
'kin bargain..... good on yer.
Chris W
Well-Known Member
- Posts
- 2,311
- Location
- Manchester
even with a cooked engine, blowing smoke out the dipstick tube and oil filler cap ???
and firing on 3 ??
major truma 2
New Member
- Posts
- 525
- Location
- rotherham
grand .....
u beat me mate ,i wanted it for my lad ,i think u should get rid of it ,,,,to me lol
well done again mate as i think it was a bargain ,,bagges first if you sell it
landrover11019
Active Member
- Posts
- 852
- Location
- essex
2.5 petrol with rangie diffs.
Wesley Pegden
Well-Known Member
- Posts
- 1,158
- Location
- Somercotes, Derbyshire.
err............... yup.
major truma 2
New Member
- Posts
- 525
- Location
- rotherham
Jay reKx
Active Member
- Posts
- 784
- Location
- tenbury wells
never mind the enjun, first job is to repaint or replace that hideous blue grille!
Chris W
Well-Known Member
- Posts
- 2,311
- Location
- Manchester
Ltwt Hybrid 300tdi
Active Member
- Posts
- 271
- Location
- Narrowboat, near Ely in the Fens
I had a 2.5 in my last lightweight series 3. It was a simple conversion and as good as you say.
Or the Ford Cologne 2.8 v6 with Steve Parker conversion plate. Had one in my series 2a and it went like the clappers, was very reliable and drank less fuel than the 2286 it replaced. Wish I still had it!
doobie
Active Member
- Posts
- 807
- Location
- North East of Scotland
I've read on the interweb in a couple of places (so must be true, right
) that the 2.8 wasnt such a great conversion as it doesnt have quite as much torque as the older 3.0litre. I dont know if the 2.8's are cast iron blocks though, the 3.0 are and weigh a ton. Parts are getting more expensive as well.
Ltwt Hybrid 300tdi
Active Member
- Posts
- 271
- Location
- Narrowboat, near Ely in the Fens
I've read on the interweb in a couple of places (so must be true, right
The 2.8 was a slightly younger engine. It had a bit more bhp, but may as you say, have had a bit less torque. Not sure. It was a cracking motor in my 2a tho. Ran it round for 7 or more years. Happy days.
- Posts
- 83,282
- Location
- Embasinga stocæ
oh stop it....no-ones ever gunna do it
In a Series - has already been done - goes like stink too. I think the guy rolled it a couple of times.
In-line, its the same as the MPI - but betterer.
otherwise I seen one with the Nissan 3.5L turbo doozil lump in it - that pretty good too
.
