Series 3 fuel gauge

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
If you google The part number Lots pop up , to have 4 duff ones sounds odd, have you done any testing on them apart from installing in dash which may not pick up any wiring/ sender faults
 

Attachments

  • 1C46A065-04A2-4062-8A43-A82B89A3BFB4.png
    1C46A065-04A2-4062-8A43-A82B89A3BFB4.png
    148.8 KB · Views: 109
The sender unit is a variable resistor and resistance changes as the float arm moves , this allows variable current to flow through the gauge and move the pointer , Usual test is to Earth the gauge lead at sender or if you have them on them bench You could put a 9v battery across the terminals and the pointer should deflect
 
I have just put a new britpart sender on it, have tested that and get a high/low resistance reading when moving the arm up and down so that seems ok, I nave put a new digital voltage regulator and get a reading of 9.8 volts from that, as I understand it if you ground the green/black it should give a full reading on the gauge, but gauge ain’t moving.
 
CD6F62A6-850D-4A4D-9681-75F0DEB97B98.jpeg


The fuel gauge is 35 above so need the 10v to one side and earth to other , if you Earth at tank there could be break in cable so no movement so best run temp new earth from gauge Terminal
Do the other gauges fail this test with direct connection of voltage and earth
 
Hi, guy’s, cracked it, did a test on the gauge on the bench and got it to work, so I think it was a bad earth, but many thanks for your input, don’t know what we would do without this forum

A bad earth on a Landy!...unheard of before...lol...good you got it sorted...
 
Back
Top