Series 3 clutch

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
I

ipfewt

New Member
Posts
6
Location
Heswall Wirral
Hi Since I reported my clutch pedal solid I have removed the gearbox, I found that the thrust bearing had seized on its shaft. I have now bought a complete clutch.
Q do I use any lubricant on the thrust bearing shaft, and what lubricant do I use on the splines.
Thanks Ian Fewtrell.
 
Blackburn said:
No lubricant on either.
Click to expand...
:rolleyes::rolleyes:

0C67E5BD-4BDF-45B4-B00B-DE02A78CEC71.png
 
I have always used a very thin smear of grease, wipe any excess off with rag, you just want it to be damp, makes assembly much easier.
 
That grease has a very good high temperature range but this tin will last you a life time and not cheap.
ROCOL® MTS 1000 Grease 500gm Tin *AFS1152 | Silmid
Personally I do not lubricate the shaft or clutch centre and have not had any issue in many years with clutch seizing on the shaft.
If you go wading a lot without fitting drain plug then leave the landrover standing it may be an issue.
Clutch plates do seize to the flywheel if left standing along time but that is normally the friction material flywheel interface.
 
You must log in or register to reply here.

Similar threads

P
Clutch stuck 300 tdi
Replies
12
Views
525
D1Nut
D1Nut
D
Spiggot bearing question
Replies
11
Views
634
David g4yvm
D
baldygit
Clutch Fitting Series 3
Replies
4
Views
518
norseman
norseman
G
Land Rover 300tdi clutch not disengaging after engine out
Replies
8
Views
1K
miktdish
miktdish
S
how to test the gearbox
Replies
6
Views
956
boguing
boguing
Back
Top