Hello - I have a series 2a. It was running fine and has been for the last year, it went under powered and sounded awful. I limped home and now it wont start. It will crank over and there is lots of white smoke. I cranked off all the injectors and there is fuel, I have bled to see if it is air and I have tested the glow plugs. Can anyone help? Thanks
Series 2 Series 2A - will turn over but won't start.
- Thread starter XTAdam
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Anaconda
Well-Known Member
- Posts
- 3,793
- Location
- Thames Valley
Load of mince pies stuffed in the air intake?
Anaconda
Well-Known Member
- Posts
- 3,793
- Location
- Thames Valley
Compression test maybe next.
I did look !
Actually I was thinking that I tested the glow plugs individually I didn't check them in the engine so perhaps that next and then compression check.
Anaconda
Well-Known Member
- Posts
- 3,793
- Location
- Thames Valley
Let's us know how you get on, its always interesting.
steve2286w
Well-Known Member
- Posts
- 4,602
- Location
- monkeyangerland
Was there any white smoke when you limped home, head gasket?
maybe a timing check, did it rev ok when driving or stationary
maybe a timing check, did it rev ok when driving or stationary
Thanks Steve, yes there was white smoke - not loads but some. Today I checked out the voltage of the glow plug circuit and that all seems fine. In the Haynes I saw this
Is this the timing you are talking about ? Because mine doesn't line up like that
It's not the best photo - but mine is off to the right. Should I line it up ? Thanks and Merry Christmas one and all !
Is this the timing you are talking about ? Because mine doesn't line up like that
It's not the best photo - but mine is off to the right. Should I line it up ? Thanks and Merry Christmas one and all !
Attachments
steve2286w
Well-Known Member
- Posts
- 4,602
- Location
- monkeyangerland
The timing pointer on the injection pump are set to the individual engine to take up wear in the chain so all it the same, assuming nuts tight timing shouldn’t have moved unless it’s jumped a tooth perhaps. agree as shedload says check fuel and air first
Sometimes the pick up pipe can pull up dirt from tank and block causing fuel starvation, which drops off when engine stopped, check lift pump is working well and followed the priming procedure as manual.
Is the stop lever in proper position
Check leak off pipes not holed and pulling in air which can cause bad running and poor starting
Is the butterfly valve in inlet manifold working properly
Are you giving 20s on the heater plugs with good battery
Sometimes the pick up pipe can pull up dirt from tank and block causing fuel starvation, which drops off when engine stopped, check lift pump is working well and followed the priming procedure as manual.
Is the stop lever in proper position
Check leak off pipes not holed and pulling in air which can cause bad running and poor starting
Is the butterfly valve in inlet manifold working properly
Are you giving 20s on the heater plugs with good battery
