series 2a gearbox

2

2afreak

New Member

Posts

6

Location

Bicker, Lincolnshire

• Dec 18, 2020

• #1

when going slow with the throttle on, off the then on again there is a clunking noise coming from the gearbox, as if gears are moving inside taking up the slack, this only happens in 1st or 2nd, not 3rd and 4th.
anyone got any idea of what it can be or point me in the right direction.
thanks

 

jamesmartin

Well-Known Member

Posts

91,879

Location

louth lincs

• Dec 18, 2020

• #2

you could check nut on end of mainshaft is tight

 

2

2afreak

New Member

Posts

6

Location

Bicker, Lincolnshire

• Dec 18, 2020

• #3

sorry but i should have said that i have undone the 6 nuts that hold the mainshaft rear bearing housing and checked the castle nut, i levered the gear with a screwdriver to see if i could move the gear to and fro and could not, the tab washer was still in place on the castle nut.

 

Blackburn

Well-Known Member

Posts

3,105

Location

Tyneside

• Dec 18, 2020

• #4

Are you sure it is the gearbox ? could be intermediate gear in transfer case if too much end float also differential and halfshaft splines worn either on shaft or flanges at hub.

 

2

2afreak

New Member

Posts

6

Location

Bicker, Lincolnshire

• Dec 18, 2020

• #5

no, i am not sure it is from the gearbox, just that it is coming from down underneath around that area
great, i will be checking the gear end float in the transfer case and and if thats ok ill move onto the halfshafts..
thanks for that.

 

L

lynall

Well-Known Member

Full Member

Posts

25,762

Location

Kent

• Dec 18, 2020

• #6

Prop u/js/drive flanges.

 

2

2afreak

New Member

Posts

6

Location

Bicker, Lincolnshire

• Dec 18, 2020

• #7

just thinking about this subject, it only does the cluncking noise in 1st or 2nd gear when you throttle on of off, and not in 3rd or 4th..

 

L

lynall

Well-Known Member

Full Member

Posts

25,762

Location

Kent

• Dec 19, 2020

• #8

2afreak said:

just thinking about this subject, it only does the cluncking noise in 1st or 2nd gear when you throttle on of off, and not in 3rd or 4th..

Click to expand...

That might be a red herring, as 1+2 are deeper gears than 3+4 so throttle movement will have more effect, inertia etc.

Have you checked the u/js and prop flamges as mentioned earlier on ?

 

C

Colthebrummie

Well-Known Member

Posts

9,870

Location

Thatcham

• Dec 19, 2020

• #9

I have a very similar cluncking noise at low speed which I believe is a worn UJ on the prop. For the noise it makes, I reckon it is badly worn but it recently passed its mot. I would have thought worn uj's were a mot inspection item.

Col