raywin
Well-Known Member
- Posts
- 3,808
- Location
- North Yorkshire
I think their service is pretty good but that's £396 for two injectors to be overhauled.
Sending injector off for testing.
- Thread starter brianconwy
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 2,141
- Location
- East of England, UK
they won’t overhaul yours they have recon units on the shelf, coded and ready to go. It’s not cheap but they are good and quick
brianconwy
Well-Known Member
- Posts
- 1,112
- Location
- conwy, north wales
I have ordered a crack detection kit to check the injector pocket in the head. If I see a crack then I will assume the injector is ok. If I don't see one then I will get another injector.
raywin
Well-Known Member
- Posts
- 3,808
- Location
- North Yorkshire
It's a big plus to have them coded, but I checked my cylinder balance with nanocom when I put mine back and they were pretty decent, I am looking to try and get an old one cheap to have a go at stripping one down, might be interesting.
sierrafery
Well-Known Member
- Posts
- 17,871
- Location
- Arad/Romania
The coding doesnt affect the cylinder balance which is relevant only at idle, it comes into play at around 3000 rpm under load so only there the engine will not behave 100% as it should or it will simply not rev much above 3000 if the coding is not OK
PopPops
Well-Known Member
- Posts
- 481
- Location
- Fareham, Hampshire
Hello Brian
To add to the confusion (!), Ribble Valley Diesels have been mentioned here before, but not in this thread. Looking at their web site, /www.ribblevalleydiesels.co.uk/, they may be a bit expensive, but another option perhaps. I've no personal experience so I can't give a recommendation, or not.
Good luck.
To add to the confusion (!), Ribble Valley Diesels have been mentioned here before, but not in this thread. Looking at their web site, /www.ribblevalleydiesels.co.uk/, they may be a bit expensive, but another option perhaps. I've no personal experience so I can't give a recommendation, or not.
Good luck.
brianconwy
Well-Known Member
- Posts
- 1,112
- Location
- conwy, north wales
I will wait to see if I can find a crack in the cylinder head. It will probably work out cheaper to get a used one.
