Second Row Door Top
- Thread starter dag019
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
v8250
Well-Known Member
- Posts
- 6,872
- Location
- Deepest Darkest...
Paintman Panels...?
I will have a look, not checked there.
I took a risk and bought the ones I was looking at that had been disassembled as they were very very cheap for what they are. Comparing them the diagram above for the front and assuming the construction is the same I think all the pieces are there other than missing one of the studs uses to attach it to the door bottom. But I am hoping to replace those with stainless anyway.
ebay LINK to the ones I bought, although I bought off facebook for less than this!
I plan to paint and then rebuild these followed by getting and building up the door bottoms with locks, cappings etc. Does anyone know where/if you can get door cards for the rear split doors? I have the military split doors at the front and have military door cards fitted to them but I am not hopeful there is an equivalent second row door version.
v8250
Well-Known Member
- Posts
- 6,872
- Location
- Deepest Darkest...
Buy some marine ply/treated chipboard and cover in your preferred vinyl, ala black. That's what I made for mine fitting into the door frame + fitted Dynamat to all doors. It really does dampen down the tininess of the doors/interior.
Can a anyone confirm if the seal between the door top and door bottom is the same for the front as it is for the second row?
I know the early 110 ali tops use a different seal to the series door tops. I think the part number is RRC7575 but that seems to come up as a front door seal on some websites. Is the same seal used for both doors?
I know the early 110 ali tops use a different seal to the series door tops. I think the part number is RRC7575 but that seems to come up as a front door seal on some websites. Is the same seal used for both doors?
They are not the same, have been out with a tape measure this morning. The front doors are 860mm wide, the second row door is 760mm wide so there must be a separate seal.
Does anyone know the part number?
