seatbelt bars - installation pictures

Hi,
Got these pair of second seatbelt bars to install but unsure what goes where. Can someone post picture of which way round the bars go on top, where the strange bracket goes on the end ? and the chassis bar below.
Thanks
They look like:-

I haven't got pictures of mine, but your first picture the one nearest the wheel arch, furthest from the viewer, is the right way up and the right way round - just lift it onto the wheel arch and it's pretty much in position. In the final picture you've got the strut that goes from the crossmember to the wheel arch in approximately the right position. There will probably be some pre-drilled holes in the crossmember which will define where the bottom end of it goes. Then with the bolt holes at the top, one receives a bolt from the seat belt and the other receives bolt that goes through the bracket on the rear end of the inner seat belt bar. And that pretty much defined where everything goes.

cheers brown. it sort of looked right, but those two L pieces forming the U on the end seemed strange - why not just have a longer bar ?

Are they off a 110? They look different to my 90. The ends of mine bend down to plates like the middle bolt plates.

One end bends down (nearest the door) to meet the chassis brace underneath, other end goes to bulkhead ? Think 90, has only two genuine stamped seat belts.

They must be off a 110, yeah mine has two seat belts either side in the back. So no idea where that bracket fits.

I don't think a 110 has a bulkhead ? So these must be 90 bars ?

A 110 with a van back has a bulkhead behind the front seats. but the ones you've got look like they're the right length for a 90, if that's the back of a 90 they're photographed in. I expect the U shaped thing is to allow some adjustment - those bolts have got big washers so I wouldn't be surprised if the holes are slotted.