Screen display

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
M

Mark74

New Member
Posts
5
My multifunction screen on my l322 has gone blank back light still lights up radio still working but screen itself is blank showing no display at all any suggestions of fault cheers
 
Common problem

The ribbon cable supplying power to the LCD display fails

Usually early signs are only a few pixels missing


Doesn't sound like this is the problem

Are you taking about the MID / stereo screen or the dash instrument screen ?
 
Last edited:
Cheers lads I'm talking about the screen in the centre of the dash above the heater control panel that displays the stereo / sat nav/ the screen display rolls down with a tape deck behind and the multiplayer in the glove box if this helps if you pull fuse 49 is that with ignition on / engine running / or everything off with key out thanks lads
 
Thanks guys for the info but still no joy it's still blank any other info or possible solutions cheers
 
Mark74 said:
Thanks guys for the info but still no joy it's still blank any other info or possible solutions cheers
Click to expand...


I might be totally wrong, but here it goes. Push the menu button on the centre screen, the look at the menu option for Monitor on/off, if it is set to off the change it to on.

If this is right then it's because I was playing with the bells and whistle and found it that the screen lights up but the display has gone.
 
Does sound like water ingress in the rear, maybe time to start stripping them out, checking for corrosion around the pins as data suggests
 
Thanks to datatek had a good check in the Nsr quarter and found pin 1 on the blue plug had corroded away completely so replaced pin terminal and hard wired it direct problem fixed thanks again to all that replied
 
Mark74 said:
Thanks to datatek had a good check in the Nsr quarter and found pin 1 on the blue plug had corroded away completely so replaced pin terminal and hard wired it direct problem fixed thanks again to all that replied
Click to expand...
I've done a couple like that:( Now fix the water leak and check all the other connectors before you end up needing a new DSP etc. The LR mod is to fit a plastic bag over the top of the kit.
 
That's prob to stop you watching the tv whilst driving . If you don't have screens in the back you can't watch tv whilst driving, so makes sense I guess?
 
Datatek said:
Water in the kit in the nearside rear of the boot is a common problem causing corrosion in the connectors at the very least.
Click to expand...

Datatek sir, you are a legend. Pulled out the blue connector, positive signs of corrosion, quick clean and "hey presto!!!" Thank you :)
 
Ok this is a nightmare I, just bought as/h unit for RR and screen still refuse to come , I have checked blue plug on the module and it shouldn’t be to blame. For the failure. .
There is a back light but nothing more but for radio cd etc. working. Help needed
 
To further this , can I dismantle the blue plug I that has the overlocking lever on it , i think this unit is responsible for controlling the display to the central monitor but open to any correction at this point? I have a suspicion it needs investigating , the black internals look like they might click out.
 
You must log in or register to reply here.

Similar threads

C
Problem with Radio unit
Replies
2
Views
199
connor303
C
J
Range rover vogue 05 Display screen gone dead
Replies
4
Views
571
Datatek
Datatek
P
L322 Blinking orange radio power light - no radio or CD player
Replies
4
Views
851
Parkheadbhoy
P
B
L322 Reservoir Valve.
Replies
12
Views
888
Mark Piercy
Mark Piercy
Freddie17
Freelander 2 (LR2) Stand-alone CarPlay screen
Replies
0
Views
140
Freddie17
Freddie17
Back
Top