MayorQuimby
Active Member
- Posts
- 290
Can someone advise the best ones to get?
Standard injection heads. Disco twin-port manifolds.
The ones I have don't seem to fit well. On some of them, the edge protrudes very slightly over the ports. Maybe by 0.5mm or so. I know it's not by much but shouldn't protrude at all...
Maybe I could take the Dremel to them lightly?
Standard injection heads. Disco twin-port manifolds.
The ones I have don't seem to fit well. On some of them, the edge protrudes very slightly over the ports. Maybe by 0.5mm or so. I know it's not by much but shouldn't protrude at all...
Maybe I could take the Dremel to them lightly?
